Industrial tyres and rims — Pneumatic tyres (metric series) on 5 degrees tapered or flat base rims w...
This document specifies the main requirements of the metric series of pneumatic tyres primarily intended for industrial vehicles, including designations, dimensions and markings. The tyres are based on the following parameters:
— speeds not exceeding 50 km/h;
— use on 5° tapered or flat base rims.
The conversion of code-designated industrial tyres into metric-designated tyres is outside the…
Health informatics — Categorial structures for representation of acupuncture — Part 1: Acupuncture p...
ISO/TS 16843-1:2016 specifies the categorial structure within the subject field of acupuncture by defining a set of domain constraints of sanctioned characteristics each composed of a semantic link and an applicable characterizing category in order to represent the concept of acupuncture point.
ISO/TS 16843-1:2016 describes sanctioned characteristics with semantic links and characterizing…
Reciprocating internal combustion engine driven alternating current generating sets — Part 13: Safet...
ISO 8528-13:2016 specifies the safety requirements for reciprocating internal combustion (RIC) engine driven generating sets up to 1 000 V consisting of an RIC engine, an alternating current (AC) generator including the additional equipment required for operating, e.g. controlgear, switchgear, auxiliary equipment.
It is applicable to generating sets for land and marine use (domestic, recreational…
Petroleum products and lubricants — Determination of roll stability of lubricating grease — Part 1: ...
This document specifies a method for evaluating the change of consistency, as measured by cone penetration, of lubricating grease when worked in the roll stability test apparatus. The method only applies to greases with cone penetration in the range 175 1/10 mm to 385 1/10 mm as measured using ISO 2137.
Safety of machinery — General principles for design — Risk assessment and risk reduction
ISO 12100:2010 specifies basic terminology, principles and a methodology for achieving safety in the design of machinery. It specifies principles of risk assessment and risk reduction to help designers in achieving this objective. These principles are based on knowledge and experience of the design, use, incidents, accidents and risks associated with machinery. Procedures are described for…
This document specifies a uniform system for grouping materials for welding purposes. It can also be applied for other purposes, such as heat treatment, forming and non-destructive testing.
Tissue-engineered medical products — Quantification of bovine type I collagen marker peptide with li...
This standard provides a method for quantification of type I collagen which was extracted from bovine tissues (e.g. skin, tendon, bone, etc.) with liquid chromatography-mass spectrometry (LC-MS).
The method described in this standard is intended to be used for collagen-based scaffold which will be used for constructing tissue-engineered medical products (TEMPs), and as well as for collagen-based…
