PPE for firefighters — Test methods and requirements for PPE used by firefighters who are at risk of...
ISO/TS 11999-2:2015 describes compatibility for ensembles of firefighters personal protective equipment (PPE) to be used by firefighters, who are at risk of exposure to high levels of heat and/or flame while fighting fires occurring in structures.
ISO/TS 11999-2:2015 includes methods for compatibility testing in laboratories and procedures for compatibility testing including the identification of…
Plastics — Determination of tensile properties — Part 2: Test conditions for moulding and extrusion ...
ISO 527-2:2012 specifies the test conditions for determining the tensile properties of moulding and extrusion plastics, based upon the general principles given in ISO 527‑1.
Security controls and implementation guidance for third party payment service providers
This document provides security controls and implementation guides for the third party payment service providers (TPPSPs). These security controls consist of
- Security governance control group
- Cross-sectional control group
- Section-specific control group
- Audit and assurance control group
In ISO/AWI TS 9546, the guidelines for security framework of information…
Road vehicles — Box task and detection response task to measure visual-manual and cognitive demand
This document defines key terms and parameters applied in the analysis of cognitive and visual-manual workload induced by transport information and control systems (TICS). It provides guidelines and minimum requirements on equipment and procedures for analysing cognitive and visual-manual load including assessment of TICS to:
— plan evaluation trials;
— specify (and install) data capture…
Biodiversity — Requirements and guidelines for the characterization of products based on native spec...
This document provides guidelines for the characterization of native species and products based on native species, which have been collected, harvested and/or processed, to enable the establishment of minimum quality and safety requirements considering sustainable management of biodiversity. A special focus is on biodiversity protection along all steps of the value chain of those products.…
Textiles — Tests for colour fastness — Part X11: Colour fastness to hot pressing
Tests are given for hot pressing when the textile is dry, when it is wet, and when it is damp. The end-use of the textile usually determines which test should be made. A dry specimen (dry pressing) or a dry specimen covered with a wet cotton adjacent fabric (damp pressing) or a wet specimen covered with a wet cotton adjacent fabric (wet pressing) are pressed with a heating device at a specified…
Water reuse in urban areas — Guidelines for the urban reclaimed water for landscaping uses
This International Standard is intended to standardize the implementation of reclaimed water for scenic environmental uses by regulating the water quality and quantity, guiding the progress of planning, operating, and management.
This International Standard is applicable to practitioners and regulatory authorities who propose to implement principles and guidelines on the implementation of…
The proposal of this new work item is to develop product standards of "dry-cured ham". The product standard mainly includes six parts: (1) the scope of application; (2) normative references; (3) terms and definitions; (4) specifications, including general, sensory, raw material, food additives, and final products requirements; (5) sampling methods; (6) labelling, packaging,…
Security and resilience — Community resilience — Framework and principles for energy resilience
This document describes the principles, framework and approach toward energy resilience.
Specifically, this document provide:
‒ a definition of energy resilience consistent with ISO 22300 (for example, Energy Resilience: ability of an energy supply chain to absorb and adapt in a changing environment).
‒ a set of essential organizational qualities of an energy supply chain required to achieve…
