Search

1 Scope [Add the following] This Standard covers the above noted products that are intended to be installed or used in accordance with CSA C22.1, the Canadian electrical Code, Part I. This clause of Part 1 is replaced by the...

1.1 These requirements cover battery-operated mobile platforms with or without a payload, as specified in 1.2. These devices are intended to be used indoors only or as outdoor use devices in a commercial or industrial...

1.1 This Standard consists of primary and supplementary graphic and control sets, 7-bit and 8-bit codes based on the above sets, and rules for code extension. The character sets are intended for general usage in data...

1 Scope 1.1 These minimum requirements cover regulators used to reduce the pressure of compressed industrial gases from a source or storage cylinder pressure of not more than 5500 psig (37.91 MPa) to the use pressure. 1.2...

This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: Replace the text, except the first paragraph, by the following new text: This part of IEC 61010 applies to automatic and...

This clause of Part 1 is applicable, except as follows: 1.1.1 Equipment included in scope Replacement: Replace the second paragraph by the following: This Part 2 of IEC 61010 specifies particular safety requirements for the...

This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: Replace the second paragraph by the following: This part of IEC 61010 specifies particular safety requirements for the...

This clause of Part 1 is applicable, except as follows: 1.1 Scope 1.1.1 Equipment included in scope Deletion: Delete the first paragraph. Replacement: Replace the second paragraph (above items a) to c)) with the following new...

1.1 These requirements apply to control panels, control units, and other various electrical circuits employed within a control circuit device intended for support functions, maintain operation and limiting safety control...

1.1 This standard applies to enclosures for electrical equipment intended to be installed and used in nonhazardous locations in accordance with the Canadian Electrical Code, Part I, CSA C22.1, the provisions of the National...

Note: The ICS Code, scope & project need for this NOI (originally published on July 12, 2022) were updated by the responsible SDO on June 18, 2024. Note: This NOI (originally published on July 12, 2022) was reissued by the...

Scope: 1 Scope 1.1 This standard applies to metallic and nonmetallic cover plates and associated gaskets for flush mounted wiring devices intended for installation in accordance with the National Electrical Code, ANSI/NFPA 70...