Search

1.1 This Standard specifies construction and testing requirements for single conductor rated 2 kV, single metallic shielded or three conductor metallic shielded power cables rated 5 kV to 35 kV, normally used in wind turbine...

1.1 This Standard covers three types of asphalt-coated glass-base sheets (asphalt-impregnated and -coated glass-roll roofing) surfaced with insoluble inorganic mineral matter: (a) Type I: a lightweight base sheet intended...

This International Standard specifies the mechanical, physical and optical characteristics of 120 mm rewritable optical disks with capacities of 4,7 Gbytes and 9,4 Gbytes. It specifies the quality of the recorded and...

1 Scope This International Standard defines communication modes for Near Field Communication Interface and Protocol (NFCIP-1) using inductive coupled devices operating at the centre frequency of 13,56 MHz for interconnection...

1. Scope This part of ISO/IEC 13522 specifies the procedure to be followed by a Registration Authority in preparing, maintaining a nd publishing a register of names (identifiers) allocated to MHEG Registered Objects. NOTE -...

1.1 This Standard applies to cords and cord sets intended for indoor use to electrically connect communication systems that have a normal operating voltage-to-ground of less than 150 V, and that are installed or used in...

1.1 This Standard covers requirements for devices to detect certain out of parameter conditions of supply voltage and/or load current and mitigate, by circuit interruption, the effects of (a) overload within utilization...

1.1 This Standard applies to single-conductor and multi-conductor Type RA90 and RC90 cables having a maximum temperature rating of 90 °C in both dry and wet locations and intended for installation in accordance with CSA C22.1...

1.1 This Standard applies to flat cable systems for indoor use, in non-hazardous locations, intended for installation on branch circuits of not more than 600 V 30 A ac between conductors in accordance with CSA C22.1, Canadian...

.1 This Standard specifies the requirements for zinc coating (galvanizing) by the hot-dipping process on iron and steel products intended or primarily for use in electrical and communication systems, made from rolled, pressed...

1.1 This Standard applies to encapsulated isolating transformers for use as a circuit continuity device, intended to be installed in airport field lighting series circuits for use in nonhazardous locations in accordance with...

1.1 This Standard establishes the testing procedure for determining efficiencies under varying loads and speeds for three-phase output variable frequency drives (VFDs) with rated voltage up to 750 V. This test procedure is...