Search

This International Standard establishes general principles and specific procedures for assessing risk.VV The purpose of this International Standard is to provide a process for making decisions relevant to the safety of lifts...

1.1 This Standard describes in POSIX terms the minimal parameters needed to localize Canadian software. Any software application distributed in Canada should be designed to conform to the presentation rules in use in Canada...

Note: The ICS code for this NOI wasupdated by the responsible SDO on April 23, 2024. Note: This NOI was withdrawn as requested by the responsible SDO on February 12, 2020. HSO's Academic Health Centres and Clinical Research...

1.1 This Standard provides requirements for primary and secondary protectors used in telecommunication networks and installed in nonhazardous locations in accordance with the Requirements of the Canadian Electrical Code, Part...

1.1 This Standard applies to the types of meters and associated devices normally used in the measurement of energy or power or both in the supply and distribution of electricity as a commodity. 1.1.1 This Standard does not...

1.1 This Standard describes the test procedures required to perform a 24 h simulated use test. This Standard also provides the calculations required to determine the first-hour rating, recovery efficiency, standby loss, daily...

1.1 Purpose This Standard establishes the principles and practices that are applicable to a Phase II ESA. It is intended to provide a consistent framework and minimum requirements for conducting Phase II ESAs that can...

1.1 This standard applies to antifouling paint for use on steel over a system comprising a vinyl pretreatment coating and a vinyl primer conforming to CGSB standards 1-GP-121 and CAN/CGSB1.122 respectively. 1.2 For more...

Note: This notice of intent was withdrawn by the responsible SDO on June 20, 2023. This Standard specifies a test method that simulates a fire that under well ventilated conditions starts in a corner of a small room with a...

1.1 This Standard applies to permanent adhesive labels and nameplates intended for use indoors or outdoors on application surfaces that are essentially clean, smooth, flat, or simple curved.* See Annex A 1.2 This Standard...

1.1 This Standard applies to complete wind turbine electrical systems and associated electrical equipment intended for connection at not more than 46 kV and intended for use in accordance with the Canadian Electrical Code...

Clause 1 of the general standard1 applies, except as follows: 201.1.1 Scope Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of AMBULATORY ELECTROCARDIOGRAPHIC SYSTEMS, hereafter...