Refine Results
Displaying 8581 - 8592 of 11296
Notice of Intent
Neutral grounding devices
1.1 This Standard applies to assemblies of resistors, enclosures, and other components that provide high impedance grounding for the purpose of controlling the ground fault current or the voltage to ground of an alternating...
Notice of Intent
7-Bit and 8-Bit Coded Character Sets for Information...
1.1 This Standard consists of primary and supplementary graphic and control sets, 7-bit and 8-bit codes based on the above sets, and rules for code extension. The character sets are intended for general usage in data...
Notice of Intent
Unplasticized Poly(Vinyl Chloride) [PVC-U] Perforated...
Purpose and scope This standard specifies the characteristics and test methods relating to perforated pipes and fittings, manufactured from unplasticized poly(vinyl chloride) [PVC-U], with a nominal diameter smaller than or...
Notice of Intent
Polyethylene (PE) Pipe for the Transport of Fluids...
PURPOSE This standard specifies the characteristics and test methods relating to solid-wall high-density polyethylene (HDPE) pipe having a hydrostatic design basis greater than or equal to 11 MPa. NOTE — The designer may...
Notice of Intent
Bare and covered ferrules
1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, Part I, CSA C22.1. 1.2...
Notice of Intent
Electric motor-operated hand-held tools, transportable...
This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to transportable drills, with manually fed axial movement of the spindle, having a maximum chuck capacity of 13 mm. NOTE 101...
Notice of Intent
Solid dielectric switchgear
1.1 This Standard applies to switchgear insulated with solid dielectric material including devices such as a) switches; b) interrupting devices, including reclosers; c) circuit breakers; and d) control, metering, protective...
Notice of Intent
Packaging for terminally sterilized medical devices...
This document provides guidance for the application of the requirements contained in ISO 11607-1 and ISO 11607-2. It does not add to, or otherwise change, the requirements of ISO 11607-1 and ISO 11607-2. This is an...
Notice of Intent
Processing of health care products - Information...
This document specifies requirements for the information to be provided by the medical device manufacturer for the processing of critical or semi-critical medical devices (i.e. a medical device that enters normally sterile...
Notice of Intent
PROCESSING OF HEALTH CARE PRODUCTS — INFORMATION...
This document specifies requirements for the information to be provided by the medical device manufacturer for the processing of non-critical medical devices not intended to be sterilized (i.e. a medical device that is...
Notice of Intent
Sterilization of health care products — Chemical...
This part of ISO 11140 specifies the performance for a Class 2 indicator to be used as an alternative to the Bowie and Dick-type test for steam sterilizers for wrapped health care goods (instruments, etc., and porous loads)...
Notice of Intent
Hardware for the support of conduit, tubing, ...
1.1 These requirements cover hardware for the support of conduit, tubing, and cable, such as HANGERS, STAPLES, STRAPS, and similar devices for installation in accordance with the National Electrical Code, NFPA 70, and the...