CAN/CGSB-43.126-2019 (R2024)

1.1 Organization and content This standard specifies the requirements for the reconditioning, remanufacturing and repair of steel and plastic drums for the transportation of dangerous goods. This standard consists of three parts and an annex. Part I specifies the general requirements for drum eligibility, and a registered facility’s quality management system. Part II specifies the requirements for the reconditioning, remanufacturing and repair of steel drums. Part III specifies the requirements for the reconditioning and remanufacturing of plastic drums. Annex A specifies the requirements for the registration of reconditioning, remanufacturing and repair facilities with Transport Canada. 1.2 Application This standard applies to standardized drums (UN/TC/DOT/CTC). 1.3 Additional requirements 1.3.1 Conflict The Transportation of Dangerous Goods Act, 1992 (TDG Act) and the Transportation of Dangerous Goods Regulations (TDG Regulations) may set out additional requirements regarding the design, construction, qualification, selection, use and testing of drums. Where there is an inconsistency between the requirements of this standard and those of the TDG Act or TDG Regulations, the TDG Act or TDG Regulations prevail to the extent of the inconsistency. It is recommended to read the standard in conjunction with the TDG Regulations. 1.3.2 Safety The reconditioning, remanufacturing and repair of a drum in accordance with this standard may require the use of materials and/or equipment that could be hazardous. This standard does not purport to address all the safety aspects associated with its use. Anyone using this standard has the responsibility to consult the appropriate authorities and to establish appropriate health and safety practices in conjunction with any applicable regulatory requirements prior to its use. 1.3.3 Units Quantities and dimensions used in this standard are given in metric units, mainly SI units.