CAN/ULC-S633:2017
1.1 This Standard sets forth the minimum requirements for primary, secondary, and coaxial types of
flexible connector pipes intended for short length transfer and containment of the specific liquid fuels (or
vapours thereof) identified in this Standard, at commercial (public) or fleet (private) automotive motor
vehicle fueling stations or similar fuel dispensing applications, and piping systems for fuel supply of
generators, burners or similar equipment.
1.2 Flexible connector pipes may be metallic, nonmetallic, or composite, but are limited to maximum
3.65 m (12 ft) lengths in nominal sizes up to 102 mm (4 in) as flexible transition components within fuel
dispensing and/or vapour recovery piping systems, typically intended for use in the following automotive
fueling station applications:
A Underground use (below surface but accessible such as within chase piping) when connected
to underground tanks or underground pipes with expected exposures to soil, water, and soil
fluids;
B Sump use (enclosed tank, transition or dispenser types) when connected to pumps, valves,
monitors, or dispensing devices with expected exposures to soil, water, soil fluids, and
occasional sunlight;
C Aboveground use (above surface but with additional physical protection, as applicable) when
connected to aboveground tanks or aboveground pipes with expected exposures to soil, water,
soil fluids, and sunlight.
1.3 Flexible connector pipes are intended for containment of automotive fuels and similar fuels or liquids
under the expected use conditions, and exposures that have similar chemical, physical and material
compatibility properties as represented in these requirements. Refer to Appendix B (Informative) for a list
of Standards on fuels and other liquids.
1.4 Products covered by this Standard are intended to be installed and used in accordance with:
A National Fire Code of Canada, Part 4;
B CSA B139, Installation code for oil-burning equipment; and
C CCME PN 1326, Environmental Code of Practice for Aboveground and Underground Storage
Tank Systems Containing Petroleum and Allied Petroleum Products.
1.5 These products are factory manufactured and intended for on-site field assembly, inspection, and
leak testing for the specified applications and use conditions by qualified persons in accordance with the
manufacturer’s instructions and local requirements.
1.6 These products are intended to be periodically inspected and maintained for continued service, or
taken out of service if necessary, by qualified persons in accordance with industry recommended practices
and/or the manufacturer’s instructions.
1.7 These products have not been evaluated for use after natural disasters, fires or exposures to
chemicals not representative of the test liquids or excessive physical damage beyond the expected
assembly, installation and uses as identified in these requirements.
1.8 These products have not been evaluated for special use piping applications where exposed to heavy
or continuous physical abuses, excessive mechanical stresses; or environments that are highly corrosive;
or operate outside of the expected ambient use temperature range for significant times.
1.9 These requirements do not cover underground piping products for liquid fuels, which are found in
CAN/ULC-S667, Standard for Metallic Underground Piping for Flammable and Combustible Liquids.
1.10 These requirements do not cover aboveground piping products for gaseous fuels (such as natural
gas, liquefied petroleum gas, propane, butane, etc.), which are found in ULC/ORD-C536, Flexible Metallic
Hose.
1.11 These requirements do not cover fuel dispensing and vapour recovery hose, which are found in
CAN/ULC-S612, Standard for Hose and Hose Assemblies for Flammable and Combustible Liquids.
SDO:
ULC
Language:
English
ICS Codes:
23.040.60;
23.040.70
Status:
Standard
Publish date:
2017-05-31
Standard Number:
CAN/ULC-S633:2017