IEC 60335-2-96:2024 EXV

IEC 60335-2-96:2024 EXV contains both the international standard and its extended version (EXV). This extended version of the official IEC Standard is available in English only and provides the user with a comprehensive content of the Standard. IEC 60335-2-96:2024 EXV includes the content of the references made to IEC 60335-1:2020. IEC 60335-2-96:2024 deals with the safety of flexible sheet heating elements intended to be incorporated into floors and walls below 1,2 m and above 2,3 m and in ceilings, their rated voltage being not more than 250 V for single-phase installations and 480 V for other installations including direct current (DC) supplied appliances. Flexible sheet heating elements are converted into heating units that are incorporated in the building in accordance with the instructions after which the required level of protection against hazards is achieved. Attention is drawn to the fact that - in many countries, different wiring rules apply; - for heating units intended to be used in vehicles or on-board ships or aircraft, additional requirements can be necessary; - in many countries, additional requirements are specified by the national authorities for fire protection, the national authorities for building regulations, the national health authorities, the national authorities responsible for the protection of labour and similar authorities. This standard does not apply to - heating units intended exclusively for industrial purposes; - heating units intended to be used in locations where special conditions prevail, such as the presence of a corrosive or explosive atmosphere (dust, vapour or gas); - blankets, pads, clothing and similar flexible heating appliances (IEC 60335-2-17); - foot warmers and heating mats (IEC 60335-2-81); - heated carpets and for heating units for room heating installed under removable floor coverings (IEC 60335-2-106); - flexible sheet heating elements incorporated in other appliances. This third edition cancels and replaces the second edition published in 2019. This edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition: a) alignment with IEC 60335-1:2020; b) conversion of some notes to normative text (Clause 1, 5.2, 7.12.101); c) correction to reinstate the touch current limit in 22.105. This part 2 is to be used in conjunction with the latest edition of IEC 60335-1 and its amendments unless that edition precludes it; in that case, the latest edition that does not preclude it is used. It was established on the basis of the sixth edition (2020) of that standard.