Road vehicles - Liquefied natural gas (LNG) fuel system components - Part 2: Performance and general test methods

Note: The scope for this NOI (originally published on February 1, 2022) was updated by the responsible SDO on April 21, 2022.

This Standard specifies general requirements and definitions of liquefied natural gas fuel system components, intended for use on the types of motor vehicles as defined in:

• In Canada: CSA B109.2.
• In the United States: NFPA 52.

It also provides general design principles and specifies requirements for instructions and marking.

This Standard is not applicable to the following:

a) fuel containers;

b) stationary gas engines;

c) container mounting hardware;

d) electronic fuel management; and,

e) fuelling receptacles.

It is recognized that miscellaneous components, not specifically covered herein can be examined to meet the criteria of this Standard and tested according to the appropriate functional tests.

All references to pressure in this Standard are to be considered gauge pressures unless otherwise specified.

This Standard is based upon a working pressure for natural gas as fuel of 1.6 MPa (232psi). Other working pressures can be accommodated by adjusting the pressure by the appropriate factor (ratio). For example, a 2 MPa (290psi) working pressure system will require pressures to be multiplied by 1.25.

 NOTE 3A For North American application, all references to working pressure are considered to be equivalent to maximum allowable working pressure (MAWP).