Press-connect metallic fittings for use in fuel gas distribution systems

CSA Group
Standards Development Organisation:
Canadian Standards Association (operating as CSA Group)
Working Program:
View the CSA work program
Designation Number:
CSA 6.32-2012
Standard Type:
Consensus SDO Standard
Standard Development Activity:
Reaffirmation
Status:
Proceeding to development
SDO Comment Period Start Date:
SDO Comment Period End Date:
Posted On:

Scope:

Scope

1.1
This standard applies to metallic (copper, steel and stainless steel) press-connect type fittings, and valves (hereafter referred to as fittings unless otherwise specified) for use with fuel gas systems intended for installation above ground, below ground, indoors and outdoors.

1.2
This standard applies to fuel gas systems rated for operating pressures not exceeding 125 psi (862 kPa).

1.3
This standard applies to fittings intended for use with fuel gas systems 3/8 inch through 4 inch nominal size.

1.4
If a value for measurement as given in this standard is followed by an equivalent value in other units, the first stated value is to be regarded as the specification. This document is based on yard/pound quantities with SI equivalents provided as a guide for making metric conversions.

1.5
Fittings and other components complying with the provisions of this standard shall be considered as having an ambient temperature range of minus 40°F (-40 °C) to 180°F (82.2°C).

1.6
This standard includes requirements to establish the suitability for use in concealed locations. (See Clause 3, Definitions)

Project need:

na

Note: The information provided above was obtained by the Standards Council of Canada (SCC) and is provided as part of a centralized, transparent notification system for new standards development. The system allows SCC-accredited Standards Development Organizations (SDOs), and members of the public, to be informed of new work in Canadian standards development, and allows SCC-accredited SDOs to identify and resolve potential duplication of standards and effort.

Individual SDOs are responsible for the content and accuracy of the information presented here. The text is presented in the language in which it was provided to SCC.