Chlorinated polyvinylchloride (CPVC) pipe, tubing, and fittings for hot- and cold-water distribution systems

1.1
This Standard covers chlorinated polyvinylchloride (CPVC) pipe, tubing, and fittings in the following sizes and uses:

a) standard dimension ratio 11 (SDR 11), and Schedules 40 and 80 pipe in pipe sizes whose dimension ratio does not exceed 11, for use in hot- and cold-water distribution systems at a maximum working pressure of 690 kPa and a maximum working temperature of 82 °C; and
b) SDR 13.5 and SDR 21 for use only in cold-water distribution and water service systems at a maximum working pressure of 2170 kPa and 1380 kPa, respectively, and a maximum working temperature of 23 °C.

Note: This Standard does not specify requirements for venting of combustion gases. In Canada, ULC S636 specifies testing and marking requirements for pipe, fittings, and accessories intended for venting of combustion gases. In the United States, UL 1738 specifies testing and marking requirements for pipe, fittings, and accessories intended for venting of combustion gases.

1.2
This Standard specifies requirements for materials, quality of work, dimensions and tolerances, hydrostatic sustained pressure strength, thermocycling resistance, solvent cement, joint strength, and markings.

1.3
In this Standard, shall is used to express a requirement, i.e., a provision that the user is obliged to satisfy in order to comply with the Standard; should is used to express a recommendation or that which is advised but not required; and may is used to express an option or that which is permissible within the limits of the Standard.

Notes accompanying clauses do not include requirements or alternative requirements; the purpose of a note accompanying a clause is to separate from the text explanatory or informative material.

Notes to tables and figures are considered part of the table or figure and may be written as requirements.

Annexes are designated normative (mandatory) or informative (non-mandatory) to define their application.