Carbon steel bars for concrete reinforcement

1.1 This Standard specifies requirements for two types of hot-rolled deformed carbon steel bars, designated regular (R) and weldable (W). The designation R is used for specifying, ordering, and communication only and is not rolled onto the bar. The designation W is rolled onto the bar (see Clauses 5 and 15). The two types are distinguished by their chemical composition requirements (see Clause 7). The bars can be in cut lengths or coils. Plain bars (Type R only) are also included in this Standard.

1.2 R grades are intended for general applications. W grades are appropriate for applications where any of the following conditions are desirable: (a) enhanced weldability; (b) enhanced ductility; (c) restricted mechanical properties; or (d) restricted chemical composition.

1.3 This Standard specifies two minimum yield strength levels, i.e., 400 MPa (designated as Grades 400R and 400W) and 500 MPa (designated as Grades 500R and 500W) (see Table 4).

1.4 Bars produced to this Standard can be welded under appropriate conditions if caution is used. Note: See CSA W186 for requirements for welding of reinforcing bars.