Aviation Turbine Fuel (Grades JET A and Jet A-1)

Designation Number:
CAN/CGSB-3.23
Standard Type:
National Standard of Canada - Domestic
Standard Development Activity:
Amendment Revision
Status:
Proceeding to development
SDO Comment Period Start Date:
SDO Comment Period End Date:
Posted On:

Scope:

1.1                This standard applies to two grades of kerosene-type aviation turbine fuel (grades JET A and JET A-1), consisting of conventional hydrocarbons, synthetic hydrocarbons, naturally occurring non-hydrocarbons and additives as specified herein. Kerosene-type aviation turbine fuels are distillates with a minimum flash point of 38°C.

1.1.1             The two grades differ only in freezing point. Grade JET A has a maximum freezing point of -40°C and Grade JET A-1 has a maximum freezing point of -47°C.

1.2                The fuels are normally used in civil aviation operations.

1.3                Limitations for Use — Aircraft operators should consult their aircraft manuals for the type of fuel, fuel additives and any temperature-related or other limitations.

1.4                Temperature Limitations — When temperatures are close to the fuel freezing-point, fuel operability problems can be experienced. JET A, with a specification freezing point of -40°C, is not intended for use during extremely cold weather conditions or when the ambient temperature is close to, or below, -40°C.  It also requires more restrictive use than JET A-1. For more information concerning temperature limitations, see Transport Canada’s Airworthiness Notice No. B021 (par. 2.1.1) and par. 8.4.

1.5                The testing and evaluation of a product against this standard may require the use of materials and/or equipment that could be hazardous. This document does not purport to address all the safety aspects associated with its use. Anyone using this standard has the responsibility to consult the appropriate authorities and to establish appropriate health and safety practices in conjunction with any applicable regulatory requirements prior to its use.

Note: The information provided above was obtained by the Standards Council of Canada (SCC) and is provided as part of a centralized, transparent notification system for new standards development. The system allows SCC-accredited Standards Development Organizations (SDOs), and members of the public, to be informed of new work in Canadian standards development, and allows SCC-accredited SDOs to identify and resolve potential duplication of standards and effort.

Individual SDOs are responsible for the content and accuracy of the information presented here. The text is presented in the language in which it was provided to SCC.