Safety and control devices for gas burners and gas-burning appliances — Particular requirements — Pa...
ISO 23551-10:2016 specifies the safety, design, construction and performance requirements and testing for automatic vent valves (hereafter referred to as "valves") for use with gas burners, gas appliances burning one or more gaseous fuels.
It is applicable to valves with declared maximum inlet pressures up to and including 500 kPa (5 bar) of nominal connection sizes up to and including…
Information and documentation — Archival paper — Requirements for permanence and durability
Contains requirements for unprinted archival paper intended for documents and publications required for permanent retention and frequent use. For these purposes paper of high performance and high durability is required.
Tyre abrasion rate measurement methods — Part 1: Outdoor test method by using vehicles on road
This international standard (part 1 or part 2) specifies the method for measuring tread abrasion mass loss of a candidate tyre per unit distance travelled, under loaded conditions, by using vehicles on road (part 1) or an external drum tester (part 2).
Each test method specified in Part 1 and Part 2 measures abrasion performance of a candidate tyre on the running mode representing vehicle driving…
Cryogenic vessels — Toughness requirements for materials at cryogenic temperature — Part 1: Temperat...
ISO 21028-1:2016 specifies the toughness requirements of metallic materials for use at a temperature below -80 °C to ensure their suitability for cryogenic vessels.
ISO 21028-1:2016 is not applicable to unalloyed steels and cast materials.
Ships and marine technology — Hopper dredger — Trailing suction tube position monitoring system
This document specifies the components and interface, technical requirements, test methods, etc. of Trailing Suction Tube Position Monitoring System of hopper dredger.
This document is applicable to the design, manufacture, modification and acceptance of the Trailing Suction Tube Position Monitoring System.
Road vehicles — Vehicle to grid communication interface — Part 21: Common 2nd generation network lay...
The document specifies all common test cases to be applied to and correctly handled by EVs (EVCC) and EVSEs (SECC) implementing ISO 15118-20 that are independent of a particular charging type (AC, DC, ACD, WPT charging). The document considers the use cases defined in ISO 15118-1:2019
The test system will comprise:
- A simulated SECC to verify the correct behaviour of a real EVCC
- A simulated…
Safety of toys — Part 4: Activity toys for domestic use
This part of ISO 8124 specifies requirements and test methods for activity toys for domestic family useintended for children under 14 years to play on or in.Products covered by this part of ISO 8124 include swings, slides, seesaws, carousels, rocking toys,climbing frames, fully enclosed toddler swing seats and other products intended to bear the mass of oneor more children.Products not included…
Plastiques — Analyse calorimétrique différentielle (DSC) — Partie 6: Détermination du temps d'i...
ISO 11357-6:2018 spécifie des méthodes de détermination du temps d'induction à l'oxydation (OIT isotherme) et de la température d'induction à l'oxydation (OIT dynamique) des matériaux polymères au moyen de l'analyse calorimétrique différentielle (DSC). Elle s'applique aux résines polyoléfines sous forme totalement stabilisée ou sous forme de composition, soit comme…
Mobile elevating work platforms — Operator (driver) training
ISO 18878:2013 provides methods for preparing training materials and administering standardized training to operators (drivers) of mobile elevating work platforms (MEWPs). It is applicable to MEWPs, as defined in ISO 16368, intended to move persons, tools and materials to positions where they can carry out work from the work platform.