Cosmetics — Analytical methods — Determination of traces of mercury in cosmetics by atomic absorbtio...
This document specifies a method for determination of mercury in cosmetics by means of cold vapour atomic absorption spectrometry (AAS) with a prior pressure digestion.
Guidance for dosimetry for sterile insects release programs
1.1 This document outlines dosimetric procedures to be followed for the radiation-induced reproductive sterilization of live insects for use in pest management programs. The primary use of such insects is in the Sterile Insect Technique, where large numbers of reproductively sterile insects are released into the field to mate with and thus control pest populations of the same species. A secondary…
Medical gas pipeline systems — Part 1: Pipelines for medical gases, medical vacuum, medical support ...
1 Scope
1.1 General
This Standard specifies safety requirements for pipelines for medical gases, medical vacuum, medical
support gases, and anaesthetic gas scavenging systems in health care facilities, both public and private.
It applies to all facilities providing health care services, regardless of type, size, location, or range of
services, including, but not limited to
a) acute care…
STANDARD FOR THERMAL INSULATION, POLYURETHANE AND POLYISOCYANURATE, BOARDS, FACED
1.1 Products that comply with the requirements of this Standard are intended for use as thermal
insulation in building construction. This Standard covers requirements and test methods for closed cell
polyurethane and polyisocyanurate foam thermal insulation in the form of flat rigid boards covered on both
sides with a facing material which impart some physical characteristics.
1.2 This closed…
Test methods for sprayed concrete — Part 1: Flash setting accelerating admixtures — Setting time
This document specifies the test method, sampling, procedure and determination of cement paste containing a flash setting accelerating admixture for sprayed concrete. Related terms and definitions are also given.
This document does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this document to establish appropriate…
BoardPolyethylene sheet for use in building construction – Material specification
This National Standard of Canada establishes a classification system and specifies physical property requirements.
Test methods to determine the properties for each class of polyethylene sheet material are specified. This document
covers a material intended to be used in building construction applications, that may be used above grade or in
contact with the ground. The material can provide the…
1 Scope
1.1
This Standard provides procedures for evaluating polymeric materials and parts made from polymeric materials intended for application in electrical equipment covered by the Canadian Electrical Code, Part II (CE Code, Part II), with respect to:
a)
flammability;
b)
mechanical properties;
c)
thermal properties;
d)
resistance to weathering; and
e)
electrical properties.
1.2…
Denatured fuel ethanol for use in automotive spark-ignition fuels
This standard applies to denatured fuel ethanol, a blending component that is used solely as a component of
automotive spark-ignition fuels.
These automotive spark-ignition fuels include:
CAN/CGSB-3.511 — Oxygenated automotive gasoline containing ethanol (E1-E10 and E11-E15), and
CAN/CGSB-3.512 — Automotive ethanol fuel (E50-E85 and E20-E25).
The testing and evaluation of a product against…
This document specifies methods for sample preparation to ensure representativeness of the samples throughout the preparation procedures to produce general analysis samples. Suitable test portions can be taken from the laboratory or general analysis samples and used for analysis according to the specific requirements defined in the corresponding analytical procedures.
This document specifies the…
Additive manufacturing — Non-destructive testing — Intentionally seeding flaws in metallic parts
This document is intended to serve as a best practice for the identification and “seeding” of nondestructively detectable flaw replicas of metal alloy PBF and DED processes. Three seeding categories are described:
a) process flaws through CAD design;
b) build parameter manipulation;
c) subtractive manufacturing.
These include flaws present within as-deposited materials, post heat-treated or HIP…