Guide for Quality Assurance Programs for Physical and Chemical Testing
Laboratories
1.1
This Special Publication gives guidelines for quality assurance in the
administration and technical operations of a laboratory performing physical or
chemical tests. It is intended to assist in developing their quality assurance
programs. Laboratories wishing to comply with specific requirements may use
these guidelines in conjunction with the requirements where applicable. These…
1. Scope
1.1
This Standard applies to motor-operated vacuum cleaners and blower cleaners,
and to household use floor finishing machines to be employed in accordance with
the Rules of the Canadian Electrical Code, C22.1, Part I and the National
Electrical Code, ANSI/NFPA 70.
1.2
These requirements cover (1) household, commercial, and coin-operated vacuum
cleaning machines and blower…
Standard Practice for Dilute-Solution Viscosity of Photodegradable Polystyrene
Scope
Z217.1
1.1 This practice outlines a method for the determination of the dilute solution viscosity of polystyrene products in tetrahydrofuran (THF). It is applicable to nondegraded and photodegraded polystyrene samples. It is used for the determination of relative viscosity (viscosity ratio), inherent viscosity (logarithmic viscosity number), intrinsic viscosity (limiting…
Test Method for Tumbling Friability of Degradable Polystyrene Foams
1. Scope
1.1
This method determines the degradation of polystyrene foams by measuring mass
loss due to a combination of abrasion and impact produced by a laboratory
tumbling device.
1.2
The values stated in metric (SI) units are to be regarded as the standard. The
values in parentheses are provided for information only.
1.3
This Standard does not purport to address all of the…
Quality assurance requirements for measuring equipment — Part 1: Metrological confirmation system fo...
Applies to: testing laboratories, including those providing a calibration service; suppliers of products or services; other organizations where measurement is used to demonstrate compliance with specified requirements.
Acoustics — Measurement of sound insulation in buildings and of building elements — Part 10: Laborat...
Applies to building elements, excluding windows and doors, with an area of less than 1 m^2 and which transmit sound between two adjacent rooms or between one room and the open air independently of the adjoining building elements. Annexes A, B and C are for information only.
Acoustics — Measurement of office screen sound attenuation under specific laboratory conditions
Describes the equipment, the test facility, the specimen, the test procedure, the calculation of the sound attenuation, the precision, the expression of results, and the contents of the test report. Annexes A, B and C are for information only.
Dental rotary instruments — Cutters — Part 3: Carbide laboratory cutters for milling machines
Specifies the dimensional and other requirements for the three most commonly used cutters with nominal sizes 010, 015, 023. A cylindrical cutter for side cutting only is shown in figure 1. A hemispherical, cylindrical cutter is shown in figure 2.
Information technology — Open Systems Interconnection — Conformance test suite for the ACSE protocol...
The conformance test suites based on this part are designed for use by: test laboratories which provide a conforming testing service for the ACSE protocol; test realizers; implementors of the ACSE protocol. Annexes A and B are for information only.
Paper, board and pulps — International calibration of testing apparatus — Nomination and acceptance ...
Provides the rules for the nomination and acceptance of laboratories in order to establish and maintain reference standards and distributing the transfer standards required to achieve interlaboratory agreement. Specifies terms and definitions. Annex A is for information only.
