This National Standard of Canada is equivalent to American National Standard
ANSI/BHMA A156.13-1987.
1.1 This Standard establishes requirements for Mortise Locks and Latches and
includes operational tests, security tests, cycle tests, finish tests, and
dimensional criteria.
1.2 Tests described in this Standard are performed under laboratory
conditions. In actual usage, results may…
1.1 All exit devices shall be listed or labeled by a nationally recognized
independent testing laboratory and be subject to periodic examination service.
1.2 Exit devices are available in Grades 1 and 2, both suitable for all
classes of buildings and are based on the performance tests listed.
1.3 The cycling requirements listed are not to be considered as being in
addition to the one…
La présente norme nationale du Canada est équivalente à la norme national
américaine ANSI/BHMA A156.3-1984.
1.1
Tous les dispositifs d'ouverture de porte d'issue doivent être listés ou
étiquetés par un laboratoire d'essai indépendant reconnu sur le plan national
et être soumis à des inspections périodiques.
1.2
Les dispositifs d'ouverture de porte d'issue sont…
Electrical and electronic measuring equipment - Documentation
Applies to the technical documentaion to be supplied with electrical and electronic measuring equipment for use in laboratories and for testing and servicing. Replaces IEC 60278 and IEC 60278A.
Accreditation System for Laboratories and Inspection Organizations - Operating
Guide
1 PURPOSe
This document defines the operating procedure system by the BNQ for the
accreditation of laboratories and inspection organizations.
Accreditation in specific testing and services sectors for which an application
has been submitted is subject to conformity with the requirements detailed in
this document, as well as to the requirements in document NQ 9902-520, and to
any…
Calibration and testing laboratory accreditation systems — General requirements for operation and re...
Sets out the general requirements for the operation of a system for accreditation of calibration and/or testing laboratories so that the accreditations granted and the services covered by the accreditations may be recognized at a national or an international level and the body operating the accreditation system may be recognized at national or international level as competent and reliable. The…
Safety Requirements for Electrical Equipment for Measurement, Control and Laboratory Use, Part 1: G...
This National Standard of Canada is based on International Standard IEC 1010-1:1990.
1.1 Scope
This International Standard specifies general safety requirements for electrical equipment intended for professional, industrial process, and educational use, including equipment and computing devices for: - measurement and test; - control; - laboratory use; - accessories intended for use with…
1.1
This Standard applies to medical gas piping systems for conducting nonflammable
medical gases used for patient care in health care facilities. Included in
this Standard are requirements pertaining to small systems such as those
serving dental suites, as well as systems providing nonflammable medical gases
to laboratories.
Notes:
(1) The manufacture, control, and distribution of…
1.1
This Standard provides guidance for the safe use of medically applied laser
systems, hereinafter referred to as medical lasers, for diagnostic,
therapeutic, and medical research purposes in health care facilities. It is
intended for use by all persons associated with the administration,
installation, operation, maintenance, and service of medical lasers.
1.2
This Standard presents…
Quality assurance requirements for measuring equipment — Part 1: Metrological confirmation system fo...
Applies to: testing laboratories, including those providing a calibration service; suppliers of products or services; other organizations where measurement is used to demonstrate compliance with specified requirements.
