Rubber seals — Joint rings used for petroleum product supply pipes and fittings — Specification for ...
Specifies requirements, but does not apply to the mentioned product with an aromatic content higher than 30 % and liquids polluted by petroleum traces. Other requirements shall be specified in national standards. Iron, steel, copper, plastics are included as pipeline materials. Not included are joint rings made of cellular rubbers. 2 tables with general and optional requirements.
Rubber seals — Joint rings used for gas supply pipes and fittings — Specification for material
Specification refers to operating temperatures up to 50 °C. Other requirements, particularly functional tests for the actual sealing materials, shall be specified in national standards. Applicable to joint rings for all pipeline materials including iron, steel, copper, plastics. The standard does not include joint rings made from cellular rubbers or with enclosed voids. 2 tables with general and…
Preferred Voltage Levels for AC Systems, 0 to 50 000 V
1. Scope
1.1 This Standard establishes voltage standards for AC Systems in Canada to provide a guide:
(a) To national committees on utilization and control equipment or devices for establishing standard ratings of such equipment or devices on a basis coordinated with standard systems;
(b) To system designers so that new systems will be designed to accommodate standard ratings of…
Guidelines for corrective action to be taken by a certification body in the event of misuse of its m...
The purpose of this Guide is to identify a series of procedures which a national certification body (non-governmental) should consider in deciding how to respond to a reported misuse of its registered mark of conformity (i.e. violation of a contract, inadequate quality control, or error in assessment of conformity) or a situation in which a certified product is subsequently found to be hazardous…
General rules for a model third-party certification system for products
The rules are valid for the following type of certification system: a third party certification system of determining conformity with product standards through initial testing and assessment of a factory quality management system and its acceptance followed by surveillance (corresponds to system No. 5 as described in ISO/ITC publication "Certification - Principles and practice"). A…
General rules for a model third-party certification system for products
The rules are valid for the following type of certification system: a third party certification system of determining conformity with product standards through initial testing and assessment of a factory quality management system and its acceptance followed by surveillance (corresponds to system No. 5 as described in ISO/ITC publication "Certification - Principles and practice"). A…
1. Scope
1.1 This Standard covers decorative and industrial plywood made primarily with hardwood veneer faces. It also includes decorative plywood made with certain softwood veneer faces.
1.2 This Standard provides minimum requirements in terms of construction, sizes, grades, sanding, and glue bond.
1.3 This Standard also applies to hardwood plywood wall panelling in all…
Codes for the Representation of Names of Countries
This National Standard of Canada is equivalent to the
International Standard ISO 3166-1981. It provides basic
two-letter alphabetic codes (ISO alpha-2 country code),
three-letter codes (ISO alpha-3 country code) for special
purposes and three-digit numerical codes (ISO numeric-3 country
codes) established by the Statistical Office of the United
Nations.
Defines Canadian content and then gives explanations and examples
of the terms in the definition. 'Canadian content', frequently an
important aspect of the procurement process, is here defined so
that it can be considered from a common understanding.