Refine Results
Displaying 10801 - 10812 of 12126
Notice of Intent
Test methods for electrical wires and cables
1.1 General This Standard describes the apparatus, test methods, and formulas to be used in carrying out the tests and calculations required by CSA electrical wire and cable Standards. 1.2 Acceptance requirements The...
Notice of Intent
Belowground reinforced thermosetting resin conduit...
1 This Standard specifies the requirements for low-halogen belowground (Type BG) reinforced thermosetting resin conduit (RTRC) and fittings, for installation and use in accordance with CSA C22.1, Canadian Electrical Code (CEC...
Notice of Intent
Fixed capacitors for use in electronic equipment...
This part of IEC 60384 is a generic specification and is applicable to fixed capacitors for use in electronic equipment. It establishes standard terms, inspection procedures and methods of test for use in sectional and detail...
Notice of Intent
Fixed capacitors for use in electronic equipment...
This part of IEC 60384 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c. (r.m.s.) or 1 000 V d.c. and with a...
Notice of Intent
Fixed capacitors for use in electronic equipment...
It should be read in conjunction with IEC 60384-1 and IEC 60384-14. This standard forms Part 14-1 of IEC 60384, which is published under the general title Fixed capacitors for use in electronic equipment. Part 1: Generic...
Notice of Intent
General requirements for double-insulated equipment
1.1 This Standard is intended to provide basic requirements for the evaluation of double-insulated cord- connected electrical equipment. 1.2 This Standard applies to equipment for use on branch circuits installed in...
Notice of Intent
Safety functions incorporating electronic technology
1.1 This Standard applies to products and component devices where the electronics technology handles the operational logic including the safety features. This Standard applies to the following configurations: a) safety...
Notice of Intent
Wiring space and wire bending space in enclosures
1.1 This Standard applies to enclosed equipment that is to be permanently field connected to line or load circuits rated 1000 V or less in accordance with CSA C22.1, Canadian Electrical Code, Part I. 1.2 This Standard applies...
Notice of Intent
Enclosed and dead-front switches for photovoltaic...
1.1 This Standard applies to enclosed and dead-front switches for use in photovoltaic (PV) systems rated 1500 V dc maximum, 1200 A maximum. 1.2 Fusible switches for photovoltaic applications are intended for use with...
Notice of Intent
Power installations exceeding 1 kV a.c. - Part...
This part of IEC 61936 provides common rules for the design and the erection of electrical power installations in systems with nominal voltages above 1 kV a.c. and nominal frequency up to and including 60 Hz, so as to provide...
Notice of Intent
Performance standard for split-system and single...
1.1 General 1.1.1 This Standard applies to unitary air conditioners and heat pumps that are a) factory-made; b) air-source and/or air-sink; c) split-system matching assemblies (including mini-split and multi-split) or single...
Notice of Intent
Requirements for the collection and transport...
This document specifies requirements and good practice recommendations for the collection and transport of samples intended for medical laboratory examinations. This document is applicable to medical laboratories and service...