Search

1.1 This Standard specifies methods for measuring electrical power consumption of equipment intended for use in commercial and industrial application when in low power mode(s) (i.e., standby mode, off mode, and network mode)...

This Standard specifies requirements for establishing and maintaining an exposure control program for engineered nanomaterials in the workplace in accordance with occupational health and safety management system (OHSMS)...

This Standard describes the performance standards, technical specifications, physical markings, and qualification tests required for breath alcohol ignition interlock devices. This Standard identifies the functional...

This International Standard establishes general principles and specific procedures for assessing risk.VV The purpose of this International Standard is to provide a process for making decisions relevant to the safety of lifts...

Note: The title and scope was updated by the responsible SDO on September 9, 2020. This standard covers devices for detection, monitoring or control of water supply and distribution systems in sizes DN 8 to DN 300 (NPS‐1/4 to...

1.1 This Standard provides requirements for primary and secondary protectors used in telecommunication networks and installed in nonhazardous locations in accordance with the Requirements of the Canadian Electrical Code, Part...

This International Standard defines the signalling procedures and protocol for the purpose of circuit-switched Call Control at the Q-reference point between Private Integrated Network Exchanges (PINXs) connected together...

1.1 This Standard describes the test procedures required to perform a 24 h simulated use test. This Standard also provides the calculations required to determine the first-hour rating, recovery efficiency, standby loss, daily...

1.1 Purpose This Standard establishes the principles and practices that are applicable to a Phase II ESA. It is intended to provide a consistent framework and minimum requirements for conducting Phase II ESAs that can...

Scope Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of CARDIAC DEFIBRILLATORS, hereafter referred to as ME EQUIPMENT. If a clause or subclause is specifically intended to be...

Replacement: This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of ULTRASONIC PHYSIOTHERAPY EQUIPMENT as defined in 201.3.216, hereafter referred to as ME EQUIPMENT. This Standard only relates...

This clause of Part 1 is applicable except as follows: 1.1 Replacement: This part of IEC 60730 applies to controls for automatically controlling the starting windings of single phase motors associated with equipment for...