Search

1.1 This Standard covers mechanical couplings that are used to axially join pipes and fittings in non-pressure drain, waste, and vent (DWV) piping systems and sewer piping systems located inside or outside buildings and above...

Note: This withdrawal NOI applies to Amendment 8:2006 This part of ISO/IEC 14496 specifies how tests can be designed to verify whether bitstreams and decoders meet requirements specified in parts 1, 2 and 3 of ISO/IEC IEC...

Note: This withdrawal NOI applies to Amendment 11:2006 This part of ISO/IEC 14496 specifies how tests can be designed to verify whether bitstreams and decoders meet requirements specified in parts 1, 2 and 3 of ISO/IEC IEC...

Note: This withdrawal NOI applies to Amendment 13:2007 This part of ISO/IEC 14496 specifies how tests can be designed to verify whether bitstreams and decoders meet requirements specified in parts 1, 2 and 3 of ISO/IEC IEC...

1.1 This Standard applies to newly produced, direct gas-fired process air heaters of the recirculating or nonrecirculating type (see Clause 3, Definitions), hereinafter referred to as heaters, whose primary purpose is to...

Note: This withdrawal NOI applies to Amendment 19:2008 This part of ISO/IEC 14496 specifies how tests can be designed to verify whether bitstreams and decoders meet requirements specified in parts 1, 2 and 3 of ISO/IEC IEC...

1.1 Purpose The purpose of this Standard is to establish criteria for the design, manufacture, testing, inspection, installation, maintenance, use, and operation of vehicle-mounted aerial devices installed on a chassis...

1.1 This standard applies to newly produced outdoor specialty gas appliances (see Clause 3), hereinafter referred to as appliances, constructed entirely of new, unused parts and materials. Appliances submitted for examination...

1.1 This test method is a standard procedure for the determination of paraffins, olefins, naphthenes, aromatics and unknowns (P.O.N.A.U.) in automotive gasolines using gas chromatography. 1.2 The final boiling point of...

This clause of Part 1 is replaced by the following. This International Standard deals with the safety of sealed (hermetic and semi-hermetic type) motorcompressors, their protection and control systems, if any, which are...

1.1 This part of ISO 11137 specifies requirements for the development, validation and routine control of a radiation sterilization process for medical devices. NOTE Although the scope of this part of ISO 11137 is limited to...

1.1 This Standard sets forth the minimum requirements for the construction and performance of overfill protection devices for installation in aboveground and underground flammable liquid and combustible liquid storage tanks...