Search

1.1 The purpose of this Standard is to specify pool pump performance measurements that will facilitate the selection of the most efficient models for performing the combined functions of filtration and pool cleaning. 1.2 This...

1.1 General This Standard specifies requirements for the identification of OHS hazards, their elimination where practical, and assessment and control of risks associated with remaining hazards. 1.2 Applicability This Standard...

1.1 This Standard provides requirements for the design of concrete containment structures of a containment system, designated as "class containment" components and parts as defined in CSA N287.1, and addresses their beyond...

This International Standard establishes the principles and specifies the procedures for developing Type III environmental declaration programmes and Type III environmental declarations. It specifically establishes the use of...

1.1 This part of ISO 10524 applies to the types of low-pressure regulators listed in 1.2 and intended to be used with the following medical gases in the treatment, management, diagnostic evaluation and care of patients: -...

1.1* This part of ISO 10524 specifies requirements for manifold pressure regulators (as defined in 3.6) intended to be connected to cylinders with nominal filling pressures up to 25 000 kPa at 15 °C and for line pressure...

1.1 This part of ISO 10524 is applicable to the types of pressure regulators listed in 1.3 intended for the administration of the following medical gases in the treatment, management, diagnostic evaluation and care of...

This International Standard specifies requirements for the oxygen compatibility of materials, components and devices for anaesthetic and respiratory applications, which can come into contact with oxygen in normal condition or...

Scope of the Project Definition Sheet: The RIDM standard will assist in addressing the following, but not limited to: a) NPP safety issues b) Engineering decision making, including design modifications c) Risk informed...

Reaffirmation 1.1 This International Standard is applicable to: - flow-metering devices that are connected, either directly or by means of flexible connecting assemblies, and disconnected by the operator at terminal units of...

Note: This NOI was withdrawn by the responsible SDO on August 15, 2023. This standard applies to Infrared Heaters that are Gas-Fired High-intensity Infrared Heaters and Gas-Fired Low-intensity Infrared Heaters with inputs up...

1.1 This standard applies to suit systems to be worn by helicopter passengers during transportation over water where thermal protection may be required. 1.2 The primary function of a suit system meeting this standard is to...