Search

The purpose of this new Standard would be to provide minimum requirements, guidance, and best practices for the quantification of vent gas emissions, standardized metering, testing, estimating and reporting requirements...

This International Standard gives formulae which allow analytical data relating to solid biofuels to be expressed on the different bases in common use. Consideration is given to corrections that can be applied to certain...

This International Standard describes methods for the determination of the total sulfur and total chlorine content in solid biofuels. This International Standard specifies two methods for decomposition of the fuel and...

Scope This part of ISO/IEC 8632 specifies a clear text encoding of the Computer Graphics Metafile. For each of the elements specified in ISO/IEC 8632-1, a clear text encoding is specified. Allowed abbreviations are specified...

Note: This NOI was been withdrawn by the SDO responsible on December 7, 2020. This Standard covers automatic water leak detection and control devices and automatic water leak detection and shut-off devices and specifies...

Specification of the physical, mechanical and dimensional characteristics of ductile iron-pipe intended for use in water pressure piping systems of diameters 75 mm through 1600 mm for bell and spigot-joint and flanged-joint...

This clause of Part 1 is applicable except as follows: Addition: This part of IEC 62841 applies to transportable bench grinders that can be equipped with one or two accessories as follows: type 1 grinding wheels in accordance...

1.1 General This part of ISO/IEC ISP 12062 covers the interchange of messages between Interpersonal Messaging (IPM) User Agents (UAs) (see also figure 1). These specifications form part of the Interpersonal Messaging...

1.1 General This part of ISO/IEC ISP 12062 covers message transfer between Message Transfer Agents (MTAs) in an Interpersonal Messaging (IPM) environment using the P1 Message Transfer Protocol (see also figure 1). These...

This Standard specifies general requirements, test methods, and markings for whirlpool and air-jetted bathtubs and suction fittings used in hydromassage bathtub systems that incorporate a bathtub and circulation pump. The...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held circular saws, which hereinafter will be referred to as saws. This standard does not apply to saws designed for use...

Object and Sope This current standard aims at specifying the characteristics of the precast concrete edgings with no reinforcement as well as the applicable controls and tests. These edgings are used namely to delineate a...