Search

1.1 Purpose The purpose of this Standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2 and Class...

1.1 This Standard specifies general requirements related to the safety of human cells, tissues, and organs used for transplantation, and includes quality system requirements. It includes aspects of safety for potential and...

This clause of Part 1 is applicable, except as follows. 1.1.1 Equipment included in scope Replacement: This part of IEC 61010 specifies safety requirements and related verification tests for control equipment of the following...

1.1 Introduction 1.1.1 The purpose of this standard is to provide minimum requirements for the design, construction, and marking of electrical equipment or parts of such equipment for use in Class I and Class II, Division 2...

1.1 This Standard describes methods for determining the occupational noise exposure level of workers (Lex,T) using sampling techniques. Lex,T represents the long-term noise exposure of workers and is calculated from...

1.1 These requirements cover hose nozzle valves that are intended to be used for the control of motor fuels as indicated in 1.3. They are of the type used in motor fuel dispensing equipment. Hose nozzle valves covered by this...

1.1 These requirements cover emergency breakaway fittings, swivel connectors and pipe-connecting fittings of the threadless compression type. Connectors and fittings covered by these requirements are intended only for the...

1.1 Applicable equipment This Standard applies to newly produced, outdoor cooking specialty gas appliances, hereinafter referred to as “appliances”, constructed entirely of new, unused parts and materials. Note: Appliances...

1.1 This Standard sets forth methods for both new installation and replacement installation of factory assembled windows, exterior doors, and skylights that are intended for installation in low-rise buildings and buildings...

CSA/ANSI 3.21:19, Part 1 - Industrial gas-fired natural draft heaters for installation in non-hazardous locations in oil and gas process applications Scope 1.1 CSA/ANSI 3.21, Industrial gas-fired natural draft heaters for...

1.1 Standard addresses This Standard is intended to address the safe, effective, and reliable reprocessing of reusable medical devices at each phase of the reprocessing workflow, including a) establishing a QMS for the MDRA...

1.1 This Standard applies to newly produced, large automatic storage water heaters having input ratings above 75,000 Btu/hr (21 980 W), instantaneous water heaters, circulating water heaters including booster water heaters...