Search

This Standard (ISO 12614-4:2014) specifies tests and requirements for the manual valve, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. ISO 12614-4:2014 is...

ISO 12614-5:2014 specifies tests and requirements for the tank pressure gauge, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. This Standard (ISO 12614-5:2014...

This Standard (ISO 12614-7:2014) specifies tests and requirements for the pressure relief valve (PRV), a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. ISO...

This International Standard defines the requirements for the symbology known as Data Matrix. It specifies the Data Matrix symbology characteristics, data character encodation, symbol formats, dimensions and print quality...

This document establishes — terms and definitions for quantifying finger image quality, — methods used to quantify the quality of finger images, and — standardized encoding of finger image quality, for finger images at 196,85...

1.1 This Standard specifies construction and testing requirements for portable power cables normally used in applications where the cables are subject to frequent flexing and where installation is in accordance with CSA M421...

1.1 This Standard specifies requirements for three-phase live-front pad-mounted distribution transformer units that (a) consist of a transformer and a separable or integral cable entrance compartment (b) are rated 75 to 3000...

This International Standard specifies the signalling ATM adaptation layer (SAAL) protocol used at the interface between B roadband PINXs and between Broadband PISNs within the framework of the B-QSIG signalling system...

This Standard applies to (a) electrode receptacles and fittings for mounting gas tubes intended for indoor and outdoor applications operating at voltages of 15 000 V and less but not exceeding 7 500 V to ground for use in...

This Standard applies to eye and face protectors used in all occupational and educational operations or processes involving hazards to the eyes or face. Typical hazards include flying objects and particles, splashing liquids...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held sanders and polishers with the exception of disc-type tools covered by IEC 62841-2-3. Tools covered by this...

New standard to address the technical requirements of multi-storey, low- to high-rise buildings of volumetric modular construction, including but not limited to provisions for: • structural design • mechanical, electrical...