Search

1.1 This Standard describes in POSIX terms the minimal parameters needed to localize Canadian software. Any software application distributed in Canada should be designed to conform to the presentation rules in use in Canada...

1.1 This Standard specifies (a) performance requirements for factory-made household dehumidifiers with a rated daily water-removal capacity of up to 87.5 L (185 U.S. pints); and (b) uniform procedures for measuring capacity...

1.1 This Standard specifies safety requirements for the design and construction of agricultural front-end loaders (front loaders) designed to be mounted on agricultural wheeled tractors (as defined in CSA M684). The purpose...

1.1 This Standard provides requirements for primary and secondary protectors used in telecommunication networks and installed in nonhazardous locations in accordance with the Requirements of the Canadian Electrical Code, Part...

1.1 This Standard applies to the types of meters and associated devices normally used in the measurement of energy or power or both in the supply and distribution of electricity as a commodity. 1.1.1 This Standard does not...

This Standard defines the framework to which capabilities of software testing tools are allocated in order to identify the capabilities of products being used by any project for software testing. Software testing processes...

This Standard defines a notation for specifying encodings of ASN.1 types or of parts of types. It provides several mechanisms for such specification, including: - direct specification of the encoding using standardized...

This Standard defines the framework to which capabilities of software testing tools are allocated in order to identify the capabilities of products being used by any project for software testing. Software testing processes...

This standard covers light-sensitive, photo electric control units of the plug-in, locking type, rated 600 volts alternating current (ac) or less, that are intended for controlling outdoor electric luminaires, in wet and damp...

1.1 This Standard describes the test procedures required to perform a 24 h simulated use test. This Standard also provides the calculations required to determine the first-hour rating, recovery efficiency, standby loss, daily...

1.1 Purpose This Standard establishes the principles and practices that are applicable to a Phase II ESA. It is intended to provide a consistent framework and minimum requirements for conducting Phase II ESAs that can...

This International Standard describes methods for the determination of the total sulfur and total chlorine content in solid biofuels. This International Standard specifies two methods for decomposition of the fuel and...