Search

1 Scope 1.1 This Standard deals with over-the-shoe toe protectors for temporary use and includes requirements for one grade of toe impact resistance. Note: This type of protector should not be confused with fully-integrated...

1.1 This Standard specifies minimum requirements for masonry materials and masonry construction. Notes: 1) Requirements for structural design of masonry are specified in CSA S304. 2) If a requirement specified in Part 9 of...

1. Scope 1.1 These requirements cover aluminum (ERMC-A) and stainless steel (ERMC-SS) electrical rigid metal conduit, nipples, elbows, and couplings in 12 - 155 (3/8 - 6) trade sizes for use as metal raceway for the...

Note: This NOI (originally published on August 30, 2022) was reissued by the responsible SDO on September 10, 2024. Note: As requested by the responsible SDO, this NOI being reissued as the standard was in the initial stages...

Note: This NOI was withdrawn by the responsible SDO on September 10, 2024. This new standard is intended to specify minimum acceptable performance/reliability targets that will also take into account the effects of climate...

1.1 This Standard describes methods for the preparation of low-basis weight handsheets of cellulose filaments (CF) and CF-reinforced pulp handsheets to be used for physical tests. 1.2 This Standard also covers the preparation...

Note: The ICS code of this Notice of Intent (originally published on September 26, 2023) was updated by the responsible SDO on July 23, 2024. This document outlines the concepts and principles for information management at a...

Note: The ICS code of this Notice of Intent (originally published on September 26, 2023) was updated by the responsible SDO on July 23, 2024. This document specifies requirements for information management, in the form of a...

IEC 62841-1:2014, Clause 1 is applicable, except as follows: Addition: This document applies to hand-held spray guns for non-flammable materials.

1.1 This Part is intended to be read together with the Standard for Low-Voltage Fuses – Part 1: General Requirements, hereafter referred to as Part 1. The titles of the Clauses in this Part correspond to the similarly titled...

This clause of Part 1 is applicable, except as follows: Addition: This part of IEC 62841 applies to hand-held circular saws, which hereinafter will be referred to as saws. This standard does not apply to saws designed for use...

1.1 These configurations cover attachment plugs, receptacles, and cord connectors, for use in accordance with the National Electrical Code (NEC), NFPA 70 and CSA C22.1, Canadian Electrical Code, Part I (CE Code). 1.2 These...