Search

1.1 This standard specifies the requirements for devices intended for positioning, which may include bundling, routing, locating, and securing of cable, wire, conduit, or tubing used in a wiring system in electrical...

1.1 Products covered 1.1.1 This standard applies to motor control centers to be used in accordance with the U. S. National Electrical Code, ANSI/NFPA 70, CSA C22.1, Canadian Electrical Code, Part 1, and the Mexican Electrical...

The Labelling & Education Standard specifies labeling requirements that will make it easy for consumers and companies to identify containers and collection points that are part of a reuse system and properly participate in...

Third-party Washing, Sanitization & Handling of Foodware Standard specifies minimum requirements and recommendations for washing, rinsing, sanitization, and drying of foodware containers. It also provides requirements and...

This Container Design Standard specifies design requirements and recommendations for reusable containers. It is applicable to containers that are intended to be part of an interoperable reuse ecosystem that utilizes common...

1.1.1 This standard applies to newly produced combination gas controls (see Definitions, Part IV), hereinafter referred to as controls, constructed entirely of new, unused parts and materials. 1.1.2 The combination control...

This clause of Part 1 is replaced by the following. This part of IEC 60335 deals with the safety of electric appliances for the care of skin or hair of persons or animals and intended for household and similar purposes, their...

1.1 This standard applies to metallic OUTLET BOXES, flush-DEVICE BOXES, FLOOR BOXES, CONCRETE BOXES, EXTENSION RINGS, covers, CONDUIT BODIES, BAR HANGERS, bar-hanger assemblies, and all accessories whose principal function is...

Note: The standard type and scope of this Notice of Intent (originally published on February 13, 2024) was updated by the responsible SDO on March 26, 2024. Note: The comment period for this NOI has been extended to March 19...

This part of IEC 60974 specifies safety and performance requirements applicable to limited duty arc welding and cutting power sources and auxiliaries designed for use by laymen. Electrically powered equipment is intended to...

This part of IEC 60079 gives requirements for the design, construction, assessment, verification and marking of rooms used to protect internal equipment: – located in a Zone 1 or Zone 2 or Zone 21 or Zone 22 explosive...

This clause of Part 1 is applicable except as follows: 1.1 Scope Replacement: This part of IEC 60730 applies to electrically operated door locks for use in, on or in association with equipment, including equipment for heating...