Search

This Standard establishes a consistent, reproducible means of evaluating the force–deflection characteristics of roll-over protective structures (ROPS) on self-propelled forestry machines under static loading, and prescribes...

This Standard specifies, in a rule-based manner, metadata elements and their attributes for the description of learning resources. This includes the rules governing the identification of metadata elements and the...

This Standard provides accompanying reference software for Rec. ITU-T H.265 | ISO/IEC 23008-2 as an electronic attachment. The software is an integral part of this document. The use of this reference software is not required...

This International Standard specifies a method for the determination of fibre length distribution parameters, principally mean length and the coefficient of variation of length, for all-wool slivers and rovings. The method is...

This Standard (ISO 12614-6:2014) specifies tests and requirements for the pressure regulator, a liquefied natural gas fuel system component intended for use on the types of motor vehicles defined in ISO 3833. ISO 12614-6:2014...

This Standard specifies interchangeable glow-starters used with pre-heat type fluorescent lamps, hereafter called starters. Section 1 specifies the general and safety requirements with which starters shall comply. Section 2...

This standard specifies the test method used to determine the in-place density of soil using a plastic rubber elastic membrane (Washington type apparatus). However, this test cannot be used on soil which deforms under slight...

1.1 This is a fire test response Standard. This document describes the test method used to determine the contribution to fire growth provided by a non-loadbearing insulated building panel installed in a sprinklered or...

Note: This notice of intent was withdrawn by the responsible SDO on February 27, 2024. Direct-type boiler and chiller fill valve assemblies with integral backflow preventer and system pressure regulator are used to control...

1.1 This standard applies to flat rigid plastic sheeting intended to provide a safe type glazing material in building construction. It shall be manufactured to prevent or reduce the likelihood of injury to persons by plastic...

1.1 This Standard provides minimum requirements for primary containment leak detection that uses quantitative assessment of physical characteristics to detect leaks in the primary containment. 1.2 These requirements do not...

Note: As requested by the responsible SDO, this NOI being reissued as the standard was in the initial stages of development for more than 12 months. An additional comment period of August 15 to September 6, 2023 (originally...