Search

1.1 This Standard specifies the requirements for the on-site manufacture and installation of light density, open cell spray applied semi-rigid polyurethane foam to produce a material that meets the physical property...

1.1 This is a fire test response Standard. This document describes the test method used to determine the contribution to fire growth provided by a non-loadbearing insulated building panel installed in a sprinklered or...

1.1 These requirements cover the design and construction of single swing Wood Core Flush Doors, which have shown by fire tests to possess sufficient properties to warrant a 20 min fire-protection rating when tested in...

This method of test for flammability characteristics is applicable to certain low density insulating materials that do not melt or drip during exposure to fire (see Appendix A). It is used in establishing the Flame Spread...

The goal of the guideline is to provide methods for modellers that result in an accurate as possible energy model. This goal can best be achieved if the guideline is a ‘living document,’ changing and growing as increasing...

1.1 These requirements cover exhaust hoods for commercial and institutional kitchens and are intended for placement over restaurant type cooking equipment, such as ranges, broilers, deep fat fryers, grills, etc., during...

1.1 This Standard specifies the physical property requirements and test methods to determine the material properties for light density, open cell spray applied semi-rigid polyurethane foam, used as a thermal insulation for...

1.1 This procedure defines the long-term thermal resistance (LTTR) of a foam product as the value measured after 5-year storage in a laboratory environment and provides means for its prediction based on an accelerated...

This part of IEC 61000 specifies EMC immunity requirements which apply to electrical and electronic equipment intended for use in power stations and substations, as described below. Immunity requirements for electromagnetic...

1.201 Scope This Collateral Standard applies to the SAFETY of MEDICAL ELECTRICAL EQUIPMENT and MEDICAL ELECTRICAL SYSTEMS incorporating PROGRAMMABLE ELECTRONIC SUBSYSTEMS (PESS), hereinafter referred to as PROGRAMMABLE...

This method of test for flammability characteristics is applicable to certain low density insulating materials that do not melt or drip during exposure to fire (see Appendix A). It is used in establishing the Flame Spread...

This Standard specifies the requirements and test methods for low pressure applied two component medium density spray polyurethane thermal insulation foam used as a thermal insulation for both building and non-building...