Search

Z241.0-03 - Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety...

Scope 1.1 This Standard defines requirements for the periodic inspection of balance of plant pressure retaining systems, components, and supports that form part of a CANDU nuclear power plant using a risk informed in-service...

Z241.0 - Definitions and General Safety Requirements for Park Model Trailers 1. Scope This Standard provides the definition of the term "park model trailer" as used in the CSA Z241 Series. It also gives general safety...

1.1 This Standard applies to the following wiring devices of the general purpose nonlocking and locking types, rated 60 A and less, and intended for use in accordance with the Canadian Electrical Code, Part I: (a) general use...

IEC 60601-1:2005+Amendment 1:2012, Clause 1 applies, except as follows: 201.1.1 Scope IEC 60601-1:2005+Amendment 1:2012, 1.1 is replaced by: This particular standard specifies requirements for the BASIC SAFETY and ESSENTIAL...

1.1 This Standard specifies methods for measuring the volume, energy consumption, and total display area (TDA) of electrically operated commercial refrigeration equipment. 1.2 This Standard applies to commercial refrigerator...

1.1 General This part of IEC 60044 applies to newly manufactured electronic current transformers having an analogue voltage output or a digital output, for use with electrical measuring instruments and electrical protective...

1.1 This Standard applies to fans and ventilation equipment that are a) cord-connected, rated at not more than 250 V; b) permanently connected to supply circuits of 600 V or less, single-phase or three-phase; c) used in non...

1.1 This Standard covers controlled outlets, equipped with or without locking or non-locking receptacle configurations, for permanently connected branch circuit installation, rated up to and including 600 V, 60A and intended...

1.1 This Standard applies to a) electrostatic air cleaners intended to remove dust and dirt from the air and intended for general indoor residential and commercial use; b) air ionizer type air cleaners; c) other similar...

This service template is compliant with the UPnP Device Architecture version 1.0 [14]. It defines a service type referred to herein as RenderingControl. 1.1 Introduction Most rendering devices contain a number of dynamically...

1 Scope 1.1 This standard sets forth minimum requirements for the following types of devices for engine fuel system applications intended for use with liquefied petroleum gas (LP-Gas), natural gas, and/or manufactured gas. a)...