Refine Results
Displaying 2821 - 2832 of 10381
Notice of Intent
Molded-case circuit breakers, molded-case switches...
1.1 The requirements of this standard cover molded-case circuit breakers, circuit breaker and ground-fault circuit-interrupters, fused circuit breakers, high-fault protectors, and high-fault modules. These circuit breakers...
Notice of Intent
Safety Requirements for Electric Fans and Regulators...
Scope This clause of IEC Publication 335-1 is applicable except as follows: 1.1 Replacement: This standard applies to electric fans and their associated regulators intended for use on single-phase a.c. and d.c. circuits not e...
Notice of Intent
Molded-case circuit breakers, molded-case switches...
1.1 The requirements of this standard cover molded-case circuit breakers, circuit breaker and ground-fault circuit-interrupters, fused circuit breakers, high-fault protectors, and high-fault modules. These circuit breakers...
Notice of Intent
Threaded conduit entries
1.1 This Standard applies to equipment for installation and use in accordance with the Rules of the Canadian Electrical Code, Part I, other than conduit couplings. 1.2 This Standard includes basic construction and inspection...
Notice of Intent
Photovoltaic systems — Design qualification of...
This International Standard is a design qualification standard applicable to solar trackers for photovoltaic systems, but may be used for trackers in other solar applications. The standard defines test procedures for both key...
Notice of Intent
Rigid polyvinylchloride (PVC) pipe and fittings...
1.1 This Standard covers rigid polyvinylchloride (PVC) pipe and fittings intended for use in pressure applications such as water mains, water service piping, and process piping. The fittings covered by this Standard include...
Notice of Intent
Occupational health and safety - Hazard identification...
1.1 General This Standard specifies requirements for the identification of OHS hazards, their elimination where practical, and assessment and control of risks associated with remaining hazards. 1.2 Applicability This Standard...
Notice of Intent
Bonding of electrical equipment
1.1 This Standard applies to electrical equipment that is intended for installation and use in accordance with the requirements of Part I of the Canadian Electrical Code (CE Code) and is a) cord connected or permanently...
Notice of Intent
Method of test for evaluation of truss plates...
1.1 This Standard provides basic procedures based on joint ultimate load or a limiting slip for the determination of the lateral strength resistance and lateral slip resistance of truss plate teeth embedded in sawn and...
Notice of Intent
Airflow ventilators for the unoccupied spaces...
1.1 This Standard gives minimum requirements for ventilators used in buildings which are designed to permit venting of unoccupied spaces to the exterior so as to minimize the unwanted accumulation of condensation, moisture...
Notice of Intent
Barbecue grill brushes
1.1 This Standard provides requirements for the performance, testing, and marking of hand-held barbecue grill brushes and replacement heads with metal bristles for consumer use, intended to clean cooking surfaces of barbecue...
Notice of Intent
Design and construction of steel storage racks
The scope of the project will include the development of a new standalone standard using the CSA S16-19 Annex N as a seed document. The Annex will be reviewed and editorially updated to bring it to standard format, for...