Search

This Technical Report (TR) covers the following: different input requirements catering for national and international practices and support of cultural and linguistic diversity; recognition of requirements regarding comfort...

These requirements cover temporary lighting strings rated not more than 20 A, 125 V, intended for indoor and outdoor use to provide temporary illumination during the period of construction, remodeling, maintenance, repair, or...

1. The Standards for foam liquid concentrates are divided into three categories. Category 1 Primarily for use on general-purpose hydrocarbon fires Category 2 Primarily for use on polar solvents, oxygenated fuels, and water...

This International Standard specifies the characteristics and location of a magnetic stripe on a savingsbook as defined in Clause 4 and the use of such savingsbooks for international interchange. Compatibility with...

1.1 This Standard sets forth minimum requirements for primary carrier, secondary containment, integral primary/secondary , normal vent and vapour recovery , metallic , composite and nonmetallic pipe, fittings, and systems...

These requirements and methods of test apply to fire damper assemblies rated 3/4 h, 1 h, 1-1/2 h, 2 h, or 3 h for use in air-conditioning and ventilating system ducts or openings (without ducts) piercing horizontally or...

1.1 This Standard applies to enclosures for electrical equipment intended to be installed and used in non-hazardous locations in accordance with the Canadian Electrical Code, Part I, CSA C22.1, the provisions of the National...

1.1 General This Standard covers the test requirements used to measure battery charger energy consumption for battery chargers intended to be operated from 115 V ac, 60 Hz line voltage connected by plug to wall receptacles or...

This Standard will become a NSC 1.1 Application This Standard applies to single- and multi-section buildings supported on longitudinal floor beams, or perimeter rim joists designed to perform as beams. 1.2 Issues addressed...

1.1 These requirements cover bare and covered ferrules intended for field wiring and factory wiring for use in accordance with the National Electrical Code, ANSI/NFPA-70 and Canadian Electrical Code, Part I, CSA C22.1. 1.2...

1.1 This Standard applies to single-polarity connectors for use with all alloys of copper or aluminum, or copper-clad aluminum conductors, or all three, for providing contacts between current-carrying parts, in accordance...

1.1 This Standard applies to single-polarity, hand-, or tool-applied splicing wire and cable connectors intended for use with all alloys of copper, aluminum conductors, or copper-clad aluminum conductors, or all three, in...