Search

This International Standard establishes general principles and specific procedures for assessing risk.VV The purpose of this International Standard is to provide a process for making decisions relevant to the safety of lifts...

1.1 This Standard describes in POSIX terms the minimal parameters needed to localize Canadian software. Any software application distributed in Canada should be designed to conform to the presentation rules in use in Canada...

This standard applies to manual drafting practices used in the preparation of all types of drawings for which microfilming is anticipated. For computer aided drafting (CAD) practices, refer to CSA Standard B78.5, Computer...

This Standard defines the framework to which capabilities of software testing tools are allocated in order to identify the capabilities of products being used by any project for software testing. Software testing processes...

This Standard defines a notation for specifying encodings of ASN.1 types or of parts of types. It provides several mechanisms for such specification, including: - direct specification of the encoding using standardized...

This Standard defines the framework to which capabilities of software testing tools are allocated in order to identify the capabilities of products being used by any project for software testing. Software testing processes...

This standard covers light-sensitive, photo electric control units of the plug-in, locking type, rated 600 volts alternating current (ac) or less, that are intended for controlling outdoor electric luminaires, in wet and damp...

1.1 This Standard provides requirements for primary and secondary protectors used in telecommunication networks and installed in nonhazardous locations in accordance with the Requirements of the Canadian Electrical Code, Part...

1.1 This Standard applies to the types of meters and associated devices normally used in the measurement of energy or power or both in the supply and distribution of electricity as a commodity. 1.1.1 This Standard does not...

Note: This notice of intent was withdrawn by the responsible SDO on June 20, 2023. This Standard specifies a test method that simulates a fire that under well ventilated conditions starts in a corner of a small room with a...

1.1 This Standard describes the test procedures required to perform a 24 h simulated use test. This Standard also provides the calculations required to determine the first-hour rating, recovery efficiency, standby loss, daily...

1.1 Purpose This Standard establishes the principles and practices that are applicable to a Phase II ESA. It is intended to provide a consistent framework and minimum requirements for conducting Phase II ESAs that can...