Search

.1 This Standard specifies the requirements for zinc coating (galvanizing) by the hot-dipping process on iron and steel products intended or primarily for use in electrical and communication systems, made from rolled, pressed...

1.1 This Standard applies to encapsulated isolating transformers for use as a circuit continuity device, intended to be installed in airport field lighting series circuits for use in nonhazardous locations in accordance with...

1.1 This Standard establishes the testing procedure for determining efficiencies under varying loads and speeds for three-phase output variable frequency drives (VFDs) with rated voltage up to 750 V. This test procedure is...

1.1 This Standard specifies the requirements for zinc coating (galvanizing) by the hot-dipping process on iron and steel products intended or primarily for use in electrical and communication systems, made from rolled...

1.1 This Standard specifies requirements for measuring the thermal efficiency, electric power consumption, and power factor of gas-fired unit heaters with a maximum input rate of 2 931 kW (10 000 000 Btu/h) or less (including...

1.1 This Standard specifies the electrical, mechanical, dimensional characteristics, test methods, and acceptance criteria for composite station post insulators for outdoor service, operating at nominal voltages greater than...

1.1 This Standard specifies the requirements for cord-connected and permanently connected industrial type heating equipment that is intended to be used in ordinary locations in accordance with CSA C22.1, Canadian Electrical...

1.1 This Standard applies to ac and dc motors with inherent overheating protection designed to be used in accordance with the Canadian Electrical Code, Part I, as follows: a) motors with a voltage rating not exceeding 600 V...

This standard applies to denatured fuel ethanol, a blendstock that is used solely as a component of automotive spark-ignition fuels. These automotive spark-ignition fuels include: CAN/CGSB-3.511 — Oxygenated automotive...

B126.0-13 - General requirements and methodsof testing for water cisterns Scope 1.1 General This Standard specifies materials, design, manufacturing practices, methods of testing, and markings for prefabricated water cisterns...

CSA B64.10:17 - Selection and installation of backflow preventers Scope 1.1 Application This Standard specifies requirements for the selection and installation of backflow preventers. Additional information on how backflow...

1.1 This Standard applies to the design, manufacturing, installation, maintenance, and operation of power presses (presses). The purpose of this Standard is to reduce the risk of injury to people working on or adjacent to...