Search

Note: The comment period for this NOI has been extended to September 25, 2024, to allow for a collaborative discussion to take place between SCC-accredited SDOs. Note: The ICS code and scope of this Notice of Intent...

1.1 General This Standard specifies requirements, in accordance with the National Building Code of Canada, for the design and strength evaluation of a) structures of reinforced and prestressed concrete; b) plain concrete...

1.1 This Standard specifies the requirements for insulating tubing that is usually round in cross-section and that consists entirely of extruded compounds whose characteristic constituents are thermosetting, elastomeric, or...

This National Standard of Canada applies to two grades of kerosene-type aviation turbine fuel (grades JET A and JET A-1), consisting of conventional hydrocarbons, synthetic hydrocarbons, naturally occurring non-hydrocarbons...

1.1 The requirements in this standard cover sealed wire connector systems, including insulating caps, covers, resins, tubing, and tapes provided with, or for use with, specific wire connectors. These systems are intended for...

1.1 This Standard specifies the requirements for insulating tubing that is usually round in cross-section and that consists entirely of extruded compounds whose characteristic constituents are thermosetting, elastomeric, or...

Please note this NOI has been replaced by the NOI for ANSI/CAN/UL/ULC-2258 (published on 2017-09-12 ). 1.1 This Standard covers minimum requirements for nonmetallic tanks of the atmospheric storage type from 227 to 2500 L...

1.1 These requirements cover pressure regulators for use with LP-Gas equipment. NOTE: For the purposes of this standard the terms “LP-Gas” and “Propane” are interchangeable. 1.2 Regulators covered by these requirements are...

1.1 These requirements cover: a) Meters for flammable and combustible liquids, of the type and size commonly used in the assembly of motor fuel dispensing devices; and b) Meters for liquefied petroleum gas (LP-Gas), of the...

This International Standard provides methods for preparing training materials and administering standardized training to operators (drivers) of mobile elevating work platforms (MEWPs). It is applicable to MEWPs, as defined in...

1.1 This Standard applies to the design, installation, operation, maintenance, and testing of emergency generators and associated equipment for providing an emergency electrical power supply to electrical loads a) in...

1. Proposed Revision And Addition Of Requirements Specific To Conduit Bodies To Distinguish Between Requirements Applicable To Conduit Bodies For Use With Rigid PVC Conduit And Requirements Applicable To Conduit Bodies For...