Search

1.1 This Standard applies to cellulose fibre loose fill thermal insulation suitable for indoor use in building construction within the temperature range of - 60 to 90 °C. 1.2 Insulation material conforming to this Standard is...

1.1 This Standard sets forth the minimum requirements for steel contained tank assemblies that are used for aboveground storage of flammable and combustible liquids such as gasoline, fuel oil, or similar products with a...

The requirements in this Standard cover emergency exit hardware , and emergency fire exit hardware that will actuate the latching mechanism on a door to allow it to swing open when force is applied to the device.

The test method in this Standard determines the wind resistance of vegetated roof assembly when subjected to dynamic wind flow and dynamic wind uplift in laboratory conditions.

This part of IEC 61000 for EMC immunity requirements applies to electrical and electronic apparatus intended for use in industrial environments, as described below. Immunity requirements in the frequency range 0 Hz to 400 GHz...

1.1 These requirements cover regulators used to reduce the pressure of compressed industrial gases from a source or storage cylinder pressure of not more than 5500 psig (37.91 MPa) to the use pressure. 1.2 Regulators covered...

Note: The scope for this NOI was updated by the responsible SDO on April 20, 2021 and the title was updated on August 16, 2022. (originally published on April 16, 2020). 1.1 This Standard outlines requirements for the...

This Standard covers the construction, operation, installation, inspection and tests applicable to fire signal receiving centres for fire protective signalling services utilizing fire signal receiving centre facilities and...

This Standard covers the principles governing the design and application of visual components used to create a safety way guidance system (SWGS) and requirements for the installation, inspection, testing and maintenance of...

The requirements in this Standard apply to frame assemblies for swinging fire doors. These frame assemblies have demonstrated performance in fire tests sufficient to warrant their use with fire doors which have been assigned...

This standard presents methodologies for characterizing and quantifying fine and ultrafine particles and volatile organic compound (VOC) emissions from operating 3D printers under normal conditions of use. This method...

1.1 These requirements cover chemical, physical and performance properties of dry chemical fire extinguishing agents for use in portable fire extinguishing equipment being evaluated to CAN/ULC-S504, Standard for Dry Chemical...