Search

1.1 This Standard covers insulated multi-pole mating or non-mating splicing wire connectors intended for field wiring and factory wiring for use in accordance with the Canadian Electrical Code, Part I, in Canada, and NFPA 70...

This National Standard of Canada applies to two types of automotive fuel: type 1, 50% to 85% by volume denatured fuel ethanol with gasoline and type 2, 20% to 25% by volume denatured fuel ethanol with gasoline. Both types are...

1.1 General This standard is divided into seven clauses that cover requirements for skin effect trace heating when installed in ordinary locations as well as in hazardous (classified) locations. Clause 1 provides the scope...

1.1 This standard applies to pin and sleeve type plugs, receptacles, power inlets, and connectors, rated up to 800 amperes and up to 600 volts ac or dc, and which may include up to eight pilot contacts. These devices are...

This clause of Part 1 is replaced by the following. This International Standard specifies safety requirements for electrically operated commercial refrigerating appliances that have an incorporated compressor or that are...

1.1 This Standard provides requirements for the design, fabrication, installation, and maintenance of single-membrane structures that are either reinforced or unreinforced and that are air-supported, frame-supported, or cable...

HSO is developing a National Standard of Canada (NSC) outlining best practices for the co-design and delivery of an integrated, people-centred spinal cord injury (SCI) rehabilitation program. The CAN/HSO S3402:2022—...

This part of IEC 60947 applies to CONTROL CIRCUIT DEVICES and SWITCHING ELEMENTS intended for controlling, signalling, interlocking, etc., of switchgear and controlgear. It applies to CONTROL CIRCUIT DEVICES having a rated...

Note: As requested by the responsible SDO, this NOI being reissued as the standard was in the initial stages of development for more than 12 months. An additional comment period of November 21 to December 12, 2023 (originally...

1.1 General This Standard provides requirements for the design and evaluation of building components of fibre-reinforced polymers (FRP) in buildings and of building components reinforced with FRP materials. It is based on...

1.1 This Standard applies to portable type gas water heaters (herein after referred to as appliance or water heater) for use with propane, butane, or liquefied petroleum gases and mixtures thereof having: a) a regulated...