Search

"This National Standard of Canada is applicable to saddles and pole clamps (stick clamps) used for live working, and to their accessories. This Standard specifies the dimensional and mechanical characteristics to be given by the manufacturer for each tool, the corresponding mechanical tests, and the other points to be checked (visual, functional, marking, etc.)"

This National Standard of Canada is based on International Standard IEC 60335-2-79:2002. 1 Scope This clause of Part 1 is replaced by the following. This International Standard deals with the safety of high pressure cleaners for household, industrial and commercial use having a pressure not less than 2,5 MPa and not more than 25 MPa and with an input to the drive for the high pressure pump not…

This National Standard of Canada is based on International Standard IEC 60384-14:2005. Scope This part of IEC 60384 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c. (r.m.s.) or 1 000 V d.c. and with a nominal frequency not exceeding 100 Hz.

This National Standard of Canada is based on International Standard ISO 11135-1:2007. Scope This part of ISO 11135 specifies requirements for the development, validation and routine control of an ethylene oxide sterilization process for medical devices. NOTE 1 Although the scope of this part of ISO 11135 is limited to medical devices, it specifies requirements and provides guidance that…

This National Standard of Canada is equivalent to International Standard ISO 15883-2:2006. 1 Scope This part of ISO 15883 specifies particular requirements for washer-disinfectors (WD) that are intended for use for the cleaning and thermal disinfection, in a single operating cycle, of re-usable medical devices such as surgical instruments, anaesthetic equipment, bowls, dishes and receivers,…

This National Standard of Canada is equivalent to International Standard ISO/TS 15883-5:2005. 1 Scope This Technical Specification includes the test soils and methods that can be used to demonstrate the cleaning efficacy of washer-disinfectors (WD) according to the ISO 15883 series of standards. The inclusion of the test soils and methods in this Technical Specification does not indicate…

This National Standard of Canada is based on International Standard ISO 15883-3:2006. 1 Scope This part of ISO 15883 specifies particular requirements for washer-disinfectors (WD) that are intended to be used for emptying, flushing, cleaning and thermal disinfection of containers used to hold human waste for disposal by one operating cycle. This part of ISO 15883 is to be applied in…

This National Standard of Canada is based on International Standard ISO 17665-1:2006. Scope 1.1 Inclusions 1.1.1 This part of ISO 17665 specifies requirements for the development, validation and routine control of a moist heat sterilization process for medical devices. NOTE Although the scope of this part of ISO 17665 is limited to medical devices, it specifies requirements and provides…

Scope 1.1 This Standard specifies requirements for the following in health care facilities: (a) hydraulic fire protection systems; (b) pure water systems; (c) drainage systems; and (d) plumbing fixtures and fittings. Note: See CAN/CSA-Z7396.1 for design, installation, certification, and maintenance requirements for non-flammable medical gas piping systems. 1.2 This Standard specifies minimum…

This National Standard of Canada is based on International Standard ISO 15883-1:2006. 1 Scope This part of ISO 15883 specifies general performance requirements for washer-disinfectors (WD) and their accessories that are intended to be used for cleaning and disinfection of re-usable medical devices and other articles used in the context of medical, dental, pharmaceutical and veterinary practice…