Systèmes de freinage - Exigences de performance et procédures d'essai - Engins
sur roues
La présente Norme nationale du Canada est basée sur la Norme internationale ISO
3450:1985.
La présente Norme internationale fixe les performances minimales et spécifie
les critères et procédures d'essai des systèmes de freinage, de façon à
permettre une évaluation reproductible de la capacité de freinage des engins de
terrassement qui travaillent sur site ou qui peuvent se déplacer…
Overall Quality Assurance Program Requirements for Nuclear Power Plants
1.1
This Standard is addressed to the owner of a nuclear power plant, hereinafter
called "the owner".
1.2
This Standard contains the requirements for the owner's overall quality
assurance program for a nuclear power plant. This program encompasses all
phases of a nuclear power plant life cycle, including site evaluation, design,
procurement, manufacturing, construction…
This National Standard of Canada is based on International Standard ISo
8873:1987 and the ASTM standard C 1029-90.
1. SCOPe
1.1 This standard specifies the requirements and test methods for
spray-applied rigid polyurethane cellular plastics used as thermal insulation
in building construction. The insulation is intended to be sprayed only into
open cavities or onto surfaces at the…
Spray-Application of Rigid Polyurethane Cellular Plastic Thermal
Insulation for Building Constructi...
1.1 This standard provides procedures to installers of spray-applied rigid
polyurethane cellular plastic thermal insulation in building construction. The
insulation is intended to be sprayed only into open cavities or onto surfaces
at the construction site. After the insulation application, the cavities or
surfaces can be enclosed.
1.2 The procedures include selection of chemical…
Commentary on the Principles for Quality Assurance Programs of CSA N286 Series Standards
1. Scope
1.1 This Special Publication is a commentary on the principles for quality assurance programs to be implemented in the phases of a nuclear power plant life-cycle, including site assessment, procurement, design, construction, commissioning, operations, and decommissioning.
Definitions and General Safety Requirements for Park Model Trailers
1. Scope
1.1
This Standard provides the definition of the term park model trailer as used in
the CAN/CSA-Z241 Series, Park Model Trailers. It also gives general safety
requirements that apply to the other Standards in the CAN/CSA-Z241 Series.
1. Scope
1.1 Requirement Specification
This Standard specifies vehicular requirements for park model trailers
including minimum requirements for the coupling and tongue or A-frame as well
as for the running gear of the trailer.
1.2 Standard Application
This Standard applies to park model trailers equipped with limited-use running
gear.
1. Scope
1.1 General
This Standard outlines the minimum requirements for materials, products,
equipment, and workmanship needed to ensure that park model trailers will
provide adequate
(a) structural strength and rigidty;
(b) protection against corrosion, decay, insects, and other similar
destructive forces;
(c) protection against the hazards of fire;
(d) resistance to the elements…
Plumbing System Requirements for Park Model Trailers
1. Scope
1.1 General
This Standard sets the minimum installation requirements and material standards
for a plumbing system in a park model trailer.
1.2 Disclaimer
This Standard is not intended as a design specification or an instruction
manual for untrained persons.
Installation Requirements for Propane Appliances and Equipment in Park
Model Trailers
1. Scope
1.1
This Standard applies to the factory installation of propane appliances and
equipment in park model trailers.
Note: CGA Standard CAN1-B149.2 was used as a basis for the preparation of this
Standard and should be consulted for installations not covered here.