Search

Gives a method for calculating the cyclic rating factor, for cables of all voltages, where partial drying out of the surrounding soil is anticipated. The method is based on one of the three methods published in a CIGRE document. The method is applicable to any type of cable, but it is recommended that it should be applied only to installations of one multi-core cable or to three single-core…

CAN/CSA-B137.0-02 Definitions, General Requirements, and Methods of Testing for Thermoplastic Pressure Piping Scope 1.1 This Standard provides requirements for thermoplastic pressure piping. It includes definitions, abbreviations, reference publications, general requirements for raw materials, general requirements for manufactured pipe and fittings, the relevant test methods, and marking…

This Standard was developed in cooperation with the Canadian Welding Bureau. 1. Scope 1.1 This Standard covers requirements for establishing and maintaining the certification of welding inspection organizations. These requirements apply to each welding inspection centre seeking certification. 1.2 This Standard provides for organizations to be certified for the inspection of one or…

1. SCOPE 1.1 Organization and Content - This standard sets out the requirements for the design and manufacture of Intermediate Bulk Containers (IBCs) with a capacity equal to or less than 3000 L and their use for the transportation of Class 3, 4, 5, 8 or 9 or Division 6.1 dangerous goods. This standard consists of two parts and three appendices. Part 1 contains the requirements for the design…

This International Standard describes a method that uses an electronic hydrogen detection instrument for measuring relative, diffusible hydrogen concentrations in bare steels or in plated steels after the coating has been removed. It is assumed that the hydrogen is uniformly distributed throughout a part. The method does not measure actual hydrogen concentration. However, oxidation current…

1. Scope 1.1 This standard states the design and performance requirements for protective clothing worn by firefighters', for protection against heat and flame encountered during fires and related life saving activities, and specifies methods for testing the materials and material assemblies used in the protective clothing. 1.2 The standard does not apply to specialized protective…

1. Scope 1.1 Purpose This Standard establishes the principles and practices that are applicable to a Phase I ESA. It is intended to provide a consistent framework and minimum requirements for conducting Phase I ESAs that can accommodate broader regulatory and liability requirements, as well as address pertinent site-specific requirements. This framework involves preparing for and…

This Technical Report provides information on the effect of water-soluble chloride and sulfate contamination levels on steel surfaces, before the application of paint or related products to surfaces prepared in accordance with standard mechanical or blast-cleaning surface preparation methods. NOTE The tolerance for water-soluble salt contamination may be different for different paint types. This…

1. Scope 1.1 This standard applies to interior and exterior corrugated fibreboard shipping containers¹ for domestic and overseas use, and the containers' interior fittings. 1.2 The testing and evaluation of a product against this standard may require the use of materials and/or equipment that could be hazardous. This document does not purport to address all the safety aspects associated…

1. Scope 1.1 This Standard provides criteria for the aspects of HVAC systems that are particular to health care facilities. These criteria lead to more stringent requirements that are above and beyond those generally applied in planning, designing, constructing, commissioning, maintaining, and operating HVAc systems. 1.2 This Standard sets values of certain parameters, identifies…