Search

1. SCOPE 1.1 This standard applies to a heavy-metal-free, water-borne primer. 1.2 The primer is suitable for use on steel and light-alloy surfaces aboard ships and on other marine structures exposed to intermittent immersion in salt water. The corrosion-inhibiting primer may be used either alone or with a topcoat. 1.3 The testing and evaluation of a product against this standard may…

1. SCOPE 1.1 This test method covers the determination of total sulphur concentrations in diesel fuel and similar middle distillates such as kerosene and aviation jet fuel in the range from 0.010 to 0.500% by mass (100 to 5000 mg/kg), using energy dispersive X-ray fluorescence spectrometry. 1.2 The testing and evaluation of a product against this method may require the use of materials and/or…

This standard specifies a generic cabling for three groups of applications in homes: Information and Communications Technologies (ICT), Broadcast and Communications Technologies (BCT), and Commands, Controls and Communications in Buildings (CCCB). It is intended to guide installations in new buildings or refurbishments, and also applies where cabling is installed to support only one or two of the…

ISO/TS 16058:2004 addresses the technical and system components of the telehealth reference architecture for telelearning systems. It does so by defining technical requirements to be satisfied for a compliant telelearning system. A compliant system will help to ensure that the telelearning technologies deployed for healthcare telelearning are capable of appropriately supporting and delivering…

1. PURPOSE AND SCOPE 1.1 This method assesses the resistance of the colour of textile materials to rubbing off in the dry state or in the presence of moisture or solvent. Such rubbing off of colour may result in fading or streaking, and/or staining of other materials. 1.2 This method is not recommended for the testing of carpets. A method assessing the colourfastness to crocking of…

1. SCOPE 1.1 This standard specifies the performance requirements for remanufactured toner cartridges for laser printers. 1.2 Some cartridges, because of their design and construction, may be more suitable than others for remanufacturing. Moreover, the life of the drum depends on the roughness of the paper used, the amount of continuous use (causing overheating), the length of time the…

ISO 17212:2004 provides and describes the usual procedures for the preparation of component surfaces prior to bonding for either laboratory evaluation or the process of construction. It is applicable to metal and plastic surfaces that are commonly encountered.

ISO 75-2:2004 specifies three methods, using different values of constant flexural stress, that can be used for the determination of the temperature of deflection under load of plastics (including filled plastics and fibre-reinforced plastics in which the fibre length, prior to processing, is up to 7,5 mm) and ebonite: method A, using a flexural stress of 1,80 MPa;method B, using a flexural…

This Technical Specification specifies requirements for instruments that measure sound intensity using pairs of pressure sensing microphones with respect to their immunity to power- and radio-frequency fields and to electrostatic discharge, and the permitted radio-frequency emissions, together with test procedures to verify conformance. Sound intensity measuring instruments are available in many…

1. SCOPE 1.1 This standard applies to a heavy-metal-free, water-borne wash primer-tie coat. 1.2 The product is suitable for use as a primer on non-ferrous metals such as aluminum, magnesium and galvanized metal, and as a tie-coat over primed zinc-rich metals. 1.3 The testing and evaluation of a product against this standard may require the use of materials and/or equipment that could be…