Search

This document describes and specifies the whole vehicle test chamber, the vapour sampling assembly and the operating conditions for the determination of volatile organic compounds (VOCs; for more information see Annex E), and carbonyl compounds in vehicle cabin air. There are three measurements performed: one (for VOCs and carbonyl compounds) during the simulation of ambient conditions (ambient…

This document specifies evaluation methods of characteristics such as pressure, flow rate, temperature and system stability of fuel gas supply systems (FGSS), which are manufactured to use vaporized liquefied natural gas (LNG) or boil-off gas as fuel gas supply to the vessel's gas consumers. It is applicable to evaluate the performance of the LNG FGSS: (1) prior to delivery or after…

This document sets out the basic methods for sampling copper, lead, zinc and nickel concentrates from moving streams and stationary lots, including stopped-belt sampling, to provide samples for chemical analysis, physical testing and determination of moisture content, in accordance with the relevant International Standards. Where the concentrates are susceptible to significant oxidation or…

This document specifies an oven-drying method for the determination of the dry matter content in suspensions of cellulosic nanomaterials. The procedure is applicable to cellulosic nanomaterial suspensions which do not contain any appreciable quantities of materials other than water that are volatile at the temperature of 105 °C ± 2 °C. It is used, for example, in the case of cellulosic…

This document specifies an oven-drying method for the determination of the dry matter content in paper, board, pulp and cellulosic nanomaterials in solid form, which all can be produced from virgin and /or recycled materials. It is also applicable to the determination of the dry matter content of paper and board for recycling. The procedure is applicable to paper, board, and pulp and cellulosic…

1 Scope 1.1 This document specifies the requirements for the on-site manufacture and installation of low pressure applied two component spray polyurethane foam to produce a material that meets the physical property requirements of CAN/ULC-S743.1, Standard for Thermal Insulation – Low Pressure Applied Two Component Spray Polyurethane Foam, Part 1: Material Specification. The material only has…

This document defines the core data set for a patient summary document that supports continuity of care for a person and coordination of their healthcare. It is specifically aimed at supporting the use case’ scenario for ‘unplanned, cross border care’ and is intended to be an international patient summary (IPS). Whilst the data set is minimal and non-exhaustive, it provides a robust, well-defined…

This document gives guidance on methods of handling, mounting and surface treatment for a biomaterial specimen prior to surface chemical analysis. It is intended for the analyst as an aid in understanding the specialized specimen-handling conditions required for analyses by the following techniques: —    X-ray photoelectron spectroscopy (XPS or ESCA); —    secondary ion mass spectrometry (SIMS…

This document gives the safety requirements and measures for stationary, manually loaded and unloaded: — single end tenoning machines with manual feed sliding table; — single end tenoning machines with mechanical feed sliding table; — single end tenoning and/or profiling machines with mechanical feed; — double end tenoning and/or profiling machines with mechanical feed, also…

This document gives the safety requirements and measures to reduce risks arising during operation, adjustment, maintenance, transport, assembly, dismantling, disabling and scrapping, related to woodworking machines capable of continuous production use, hereinafter referred as "machines". These safety requirements and measures are those common to most of the machines, when they are used…