Plastics — Determination of the ultimate anaerobic biodegradation under high-solids anaerobic-digest...
ISO 15985:2014 specifies a method for the evaluation of the ultimate anaerobic biodegradability of plastics based on organic compounds under high-solids anaerobic-digestion conditions by measurement of evolved biogas at the end of the test. This method is designed to simulate typical anaerobic digestion conditions for the organic fraction of mixed municipal solid waste. The test material is…
General principles for the management of radioactive waste and irradiated fuel
1.1
This Standard specifies common requirements for the management of radioactive waste and irradiated
fuel from generation to storage or disposal.
1.2
This Standard is used in concert with all CSA standards that apply to the management of radioactive
waste and irradiated fuel.
Note: For example, CSA N292.2, CSA N292.3, CSA N292.5, and CSA N294.
1.3
This Standard applies to waste…
Live working – Minimum approach distances for a.c. systems in the Voltage range 72,5 kV to 800 kV – ...
This International Standard describes a method for calculating the minimum approach
distances for live working, at maximum voltages between 72,5 kV and 800 kV. This standard
addresses system overvoltages and the working air distances or tool insulation between parts
and/or workers at different electric potentials.
The required withstand voltage and minimum approach distances calculated by the…
Quasi-static calibration procedure for belt force transducers
ISO/TS 17242:2014 provides a procedure to calibrate seat belt force transducers with loading capacities up to 25 kN and consistent test specifications and sequences in order to improve comparability of measurement results between testing laboratories.
Test method for assessing the performance of gas-phase air cleaning media and devices for general ve...
ISO 10121-1:2014 aims to provide an objective laboratory test method, a suggested apparatus, normative test sections and normative tests for evaluation of three different solid gas-phase air cleaning media (GPACM) or GPACM configurations for use in gas-phase air cleaning devices intended for general filtration applications. ISO 10121-1:2014 is specifically intended for challenge testing and not…
Inlet air cleaning equipment for internal combustion engines and compressors — Performance testing
ISO 5011:2014 establishes and specifies uniform test procedures, conditions, equipment, and a performance report to permit the direct laboratory performance comparison of air cleaners.
The basic performance characteristics of greatest interest are air flow restriction or differential pressure, dust collection efficiency, dust capacity, and oil carry-over on oil bath air cleaners. This test code…
Scope
1.1
This Standard provides guidance for the safe use of lasers in health care. It applies to all procedures in health care settings where health-related lasers are used, including, but not limited to, the following:
a) health care facilities;
b) dental clinics, offices, and facilities;
c) veterinary facilities;
d) laboratories and other research facilities;
e) physician offices;
f)…
Medical electrical equipment — Part 2-61: Particular requirements for basic safety and essential per...
This Standard covers ME EQUIPMENT that is intended to be installed or used in accordance with
CSA C22.1, Canadian Electrical Code, Part I.
Subclause 1.1 of The general standard is replaced by:
This International Standard applies to the BASIC SAFETY and ESSENTIAL PERFORMANCE of PULSE OXIMETER
EQUIPMENT intended for use on humans, hereafter referred to as ME EQUIPMENT. This includes any part…
Corrugating medium — Determination of the edge crush resistance after laboratory fluting
ISO 16945:2014 specifies two methods for the determination of the edge crush resistance of a corrugating medium after laboratory fluting. The procedures are applicable to any corrugating medium to be used after fluting in the manufacture of corrugated fibreboard.
