Search

ISO 5603:2017 specifies two methods for determining the adhesion strength of vulcanized rubber to wire cord which is embedded in the rubber. The two methods do not necessarily give the same results. They are applicable primarily to test pieces prepared in the laboratory under standard conditions and used for the development and control of materials and processes utilized in the manufacture of…

ISO 814:2017 specifies a method for determining the adhesion strength of rubber-to-metal bonds where the rubber part is assembled between two parallel metal plates, using the adhesive system under investigation. The method is applicable primarily to test pieces, prepared in the laboratory under standard conditions, such as can be used to provide data for the development of rubber compounds and…

IEC 61745:2017 describes the calibration of test sets that perform end-face image analysis, also known as "near-field" or "grey-scale" analysis. The principles, however, can be applied to test sets of a different type. The procedures outlined are performed by calibration laboratories and by the manufacturers or users of geometry test sets, for the purpose of calibrating…

ISO 17781:2017 specifies quality control testing methods and test conditions for the characterization of microstructure in relation to relevant properties in ferritic/austenitic (duplex) stainless steel components supplied in the solution annealed condition and fabrication welds in the as welded condition. ISO 17781:2017 supplements the relevant product and fabrication standards with respect to…

ISO 14239:2017 specifies six suitable incubation systems for measuring the rates and extent of mineralization of organic compounds in soil by measurement of carbon dioxide (CO2) evolution. All incubation systems are applicable to soluble or insoluble compounds but choice of system depends on the overall purposes of the study. ISO 14239:2017 does not apply to the use of such systems for material…

ISO 13506-1:2017 specifies the overall requirements, equipment and calculation methods to provide results that can be used for evaluating the performance of complete garments or protective clothing ensembles exposed to short duration flame engulfment. This test method establishes a rating system to characterize the thermal protection provided by single-layer and multi-layer garments made of flame…

ISO 1431-3:2017 describes three types of method for the determination of ozone concentration in laboratory test chambers. Method A ? UV absorption: this is the reference method, and is used as the means of calibration for the alternative methods B and C. Method B ? Instrumental techniques: B1: electrochemical B2: chemiluminescence Method C ? Wet-chemical techniques: Procedure I Procedure II…

1 Scope and object This clause of Part 1 is applicable, except as follows: 1.1.1 Equipment included in the scope Replacement: Replace the first paragraph by the following: This group safety publication is primarily intended to be used as a product safety standard for the products mentioned in the scope, but shall also be used by technical committees in the preparation of their publications…

1 Scope and object This clause of Part 1 is applicable except as follows: 1.1.1 Equipment included in scope Replacement: Replace the first paragraph by the following: This group safety publication is primarily intended to be used as a product safety standard for the products mentioned in the scope, but shall also be used by technical committees in the preparation of their publications for…