Rock drilling equipment — Drill rods with tapered connection for percussive drilling
Lays down the basic dimensions of drill rods and the necessary dimensions of the tapered connections. These dimensions shall comply with those given in figure 1 and table 1 and in figure 2 and table 2, respectively.
Welding of Reinforcing Bars in Reinforced Concrete Construction
1. Scope
1.1 This Standard applies to
(a) the design, fabrication, and inspection of welded connections utilizing deformed reinforcing bars and to the certification of companies involved in such work;
(b) welding of deformed reinforcing bars (except for pre- stressing steel or for bar or rod mats for which the welding is covered by the manufacturing specification) either directly…
1. Scope
1.1 This Standard applies to single or multiple conductor, round, flat, or coiled appliance wiring material products for use as follows:
(a) Class I Internal: Group (A) - where not subjected to mechanical abuse. Group (B) - where may be subjected to mechanical abuse. (1) Wet (2) Oil; and
(b) Class II External: Group (A) - where not subjected to mechanical abuse. Group (B) -…
Passenger cars — Wiper systems — Shaft ends and arm-holes
Specifies the main dimensions and general requirements for wiper arm to shaft end connections of wiper systems. Gives the preferred type 1; the normative annex A includes the non-preferred type 2.
Specifies the basic dimensions and access clearance. The basic dimensions shall be as specified in figure 1. The clearance allowed around the connector shall be in accordance with figure 2.
Connectors for frequencies below 3 MHz for use with printed boards. Part 8: Two-part connectors for ...
Applies to a group of related two-part connectors for printed boards for board-to-board and board-to-wire connection, with tin or gold plated contact area according to the style. The free or fixed board-mounted connectors are provided with terminations suitable for printed boards in accordance with IEC 60326 and using a grid of 2.54 mm (0.1 in) as laid down in IEC 60097.
Medical Electrical Equipment Part 1: General Requirements for Safety
This National Standard of Canada is based on International Standard IEC 601-1:1988.
NOTE - Amendment 2:1998 to this document was reaffirmed November 10, 2006.
It applies to the safety of MEDICAL ELECTRICAL EQUIPMENT (as defined in
Sub-Clause 2.2.15) designed to be installed and used in accordance with the
rules of the Canadian Electrical Code, Part I. Although this Standard is
primarily…
Connectors for frequencies below 3 MHz for use with printed boards. Part 9: Two-part connectors for ...
Covers a group of related two-part connectors for printed boards and cable connectors associated with printed backpanels. The group covers high-density connectors having up to 96 miniature contacts for low-voltage applications, connectors having up to 6 high current contacts, combined with up to 42 signal contacts and a range of 4, 10, 20 and 64 way female cable connectors and associated male…
