Search

ISO 7176-11:2012 specifies requirements for test dummies of any mass greater than or equal to 25 kg, to be used in the evaluation of wheelchairs. ISO 7176-11:2012 provides formulae that specify the location of the overall centre of mass of test dummies, the masses of the segments that comprise the test dummies and the locations of pivots that connect the segments. It also specifies the…

1 Scope [Add the following] This Standard applies to the safety of such equipment designed and constructed for installation and use in accordance with the Rules of the Canadian Electrical Code, Part I. Products covered by the scope of this Standard are also subject to the requirements of CAN/CSA-C22.2 No. 0. [Add a third dashed item to NOTE 101] – this Standard applies to both cord-…

Scope 1.1 This Standard applies to solid-state lighting controls rated at 600 V and less, with or without an integral switching (disconnecting) device, designed to be used in circuits (a) for the control of incandescent lamps; and (b) for the control of fluorescent, HID, ballasted, and similar lamps intended for installation in accordance with the Rules of the Canadian Electrical Code, Part I…

Scope 1.1 This standard applies to metallic (copper, steel and stainless steel) press-connect type fittings, and valves (hereafter referred to as fittings unless otherwise specified) for use with fuel gas systems intended for installation above ground, below ground, indoors and outdoors. 1.2 This standard applies to fuel gas systems rated for operating pressures not exceeding 125 psi (862…

Scope 1.1 These requirements are intended to cover both self-ballasted lamps and self-ballasted lamp adapters rated 120 to 347 V AC nominal for connection to screw-base, pin-base, or recessed single contact (RSC or R7) lampholders. These devices are intended for use in accordance with the National Electrical Code, ANSI/NFPA 70, and the Canadian Electrical Code, Part I, in non-hazardous locations…

ISO/TR 11364:2012 lists the different valve stem to gas cylinder connection threads currently and historically existing worldwide and provides official coded designations for them. These coded designations will then be available for identification and marking purposes. It also gives guidance concerning which threads are dimensionally identical and which are interchangeable. Furthermore, it…

IEC 62488-1:2012 applies to the planning of analogue and digital power line carrier systems operating over EHV/HV/MV electricity grids. The object of this standard is to establish the planning of the services and performance parameters for the operational requirements to transmit and receive data efficiently over power networks. The transmission media used by the different electricity supply…

La CEI 62488-1:2012 s'applique à la conception des systèmes à courants porteurs de lignes d'énergie analogiques et numériques fonctionnant sur des réseaux d'électricité EHT/HT/MT. Elle a pour objet de définir la conception des services et des paramètres de performance relatifs aux exigences opérationnelles en matière d'émission et de réception efficace des données sur les…

ISO 17268:2012 defines the design, safety and operation characteristics of gaseous hydrogen land vehicle (GHLV) refuelling connectors consisting of, as applicable, a receptacle and a protective cap (mounted on vehicle), and a nozzle. It applies to refuelling connectors which have working pressures of 11 MPa, 25 MPa, 35 MPa and 70 MPa, referred to as H11 - 11 MPa at 15 °C, H25 - 25 MPa at 15 °C,…

ISO 16438:2012 specifies requirements and test methods for reinforced and non-reinforced thermoplastic collapsible hoses, which are intended to be used as main and sub-main supply lines for the conveyance and distribution of water for irrigation at water temperatures up to 50 °C. It is applicable to irrigation hoses with nominal diameters between 40 mm and 500 mm and working pressures between 0,3…