Dentistry — Minimal dental implant data set for clinical use
ISO 16498:2013 specifies the minimal data set to be recorded for a patient receiving dental implant treatment. This will comprise the locations and types of dental implant bodies, connecting components and adjunctive devices, including grafting materials, placed in a patient's jaw(s).
Low-voltage fuses - Part 2: Supplementary requirements for fuses for use by authorized persons (fuse...
IEC 60269-2:2013 provides supplementary requirements for fuses for use by authorized persons and are generally designed to be used in installations where the fuse-links are accessible to, and may be replaced by, authorized persons only. Fuses for use by authorized persons according to the following fuse systems also comply with the requirements of the corresponding subclauses of IEC 60269-1,…
Fuel cell technologies - Part 3-201: Stationary fuel cell power systems - Performance test methods f...
IEC 62282-3-201:2013 provides test methods for the electric/thermal and environmental performance of small stationary fuel cell power systems that meet the following criteria:
- output: nominal electric power output of less than 10 kW;
- output mode: grid-connected/independent operation or stand-alone operation with single-phase AC output or 3-phase AC output not exceeding 1 000 V, or DC output…
Low-voltage switchgear and controlgear — Part 1: General rules
This standard applies, when required by the relevant product standard, to switchgear and controlgear
hereinafter referred to as ²equipment² and intended to be connected to circuits, the rated voltage of which
does not exceed 1 000 V a.c. or 1 500 V d.c.
It does not apply to low-voltage switchgear and controlgear assemblies which are dealt with in IEC 60439.
NOTE – In certain clauses or…
Scope
1.1
This standard applies to newly produced outdoor specialty gas appliances (see Clause 3), hereinafter referred to as appliances, constructed entirely of new, unused parts and materials. Appliances submitted for examination under this standard shall be classified as portable. These products are not intended for commercial use.
1.2
This standard applies to recreational vehicle grills (see…
Solderless connections - Part 2: Crimped connections - Generalrequirements, test methods and practic...
IEC 60352-2:2006+A1:2013 Determines the suitability of solderless crimped connections under specified mechanical, electrical and atmospheric conditions and provides a means of comparing test results when the tools used to make the connections are of different designs or manufacture. This consolidated version consists of the second edition (2006) and its amendment 1 (2013). Therefore, no need to…
Printed board assemblies - Part 2: Sectional specification - Requirements for surface mount soldered...
IEC 61191-2:2013 gives the requirements for surface mount solder connections. The requirements pertain to those assemblies that are totally surface mounted or to the surface mounted portions of those assemblies that include other related technologies (e.g. through-hole, chip mounting, terminal mounting, etc.). This edition includes the following significant technical changes with respect to the…
Fixed capacitors for use in electronic equipment - Part 14: Sectional specification - Fixed capacito...
IEC 60384-14:2013 applies to capacitors and resistor-capacitor combinations which will be connected to an a.c. mains or other supply with nominal voltage not exceeding 1 000 V a.c. (r.m.s.) or 1 000 V d.c. and with a nominal frequency not exceeding 100 Hz. This fourth edition cancels and replaces the third edition published in 2005. It constitutes a technical revision. All changes that have been…
