Search

IEC 60695-1-30:2008 provides guidance for assessing and choosing candidate materials, components or sub-assemblies for making an end-product based upon preselection testing. It describes how preselection provides comparative fire hazard test methods to evaluate the performance of a test specimen and how preselection can be used in the selection of materials, parts, components and sub-assemblies…

IEC 61290-3-2:2008 applies to optical fibre amplifiers (OFA) using active fibres, containing rare-earth dopants, presently commercially available. Establishes uniform requirements for accurate and reliable measurements, of the noise figure, as defined in 3.1.17 of IEC 61291-1, by means of the electricial spectrum analyzer (ESA) method. This technical revision includes updates to specifically…

ISO 13885-1:2008 describes the determination of the molar-mass distribution, number-average molar mass Mn and mass-average molar mass Mw of polymers that are soluble in THF (tetrahydrofuran) by gel permeation chromatography (GPC) [also known as size exclusion chromatography (SEC)]. It is possible that, in spite of the good repeatability obtained with this method, it cannot be used with certain…

Deals with the safety of electric food waste disposers for household and similar purposes, their rated voltage being not more than 250 V. This standard does not apply to portable food waste disposers; food waste disposers of the incinerator type; appliances intended exclusively for industrial or commercial purposes; appliances intended to be used in locations where special conditions prevail,…

CISPR 16-2-5:2008(E) deals with in situ electromagnetic disturbance measurements in any environment from physically large equipment and systems excluding networks. It covers both radiated and conducted emission phenomena, and does not deal with immunity tests. This technical report is intended to be applied primarily to such physically large equipment which are not under the scope of any existing…

IEC 61076-2-101:2008 describes circular connectors M12 typically used for industrial process measurement and control. These connectors consist of fixed and free connectors with screw-locking. Male connectors have round contacts of diameters 0,6 mm, 0,76 mm, 0,8 mm and 1,0 mm. This new edition includes the following significant technical change with respect to the previous edition: the connector…

ISO/IEC 14443 is one of a series of International Standards describing the parameters for identification cards as defined in ISO/IEC 7810, and the use of such cards for international interchange. ISO/IEC 14443-4:2008 specifies a half-duplex block transmission protocol featuring the special needs of a contactless environment and defines the activation and deactivation sequence of the protocol. ISO…

ISO 16730:2008 provides a framework for assessment, verification and validation of all types of calculation methods used as tools for fire safety engineering. It does not address specific fire models, but is intended to be applicable to both analytical models and complex numerical models that are addressed as calculation methods in the context of this International Standard. It is not a step-by-…

ISO/IEC 14443 is one of a series of International Standards describing the parameters for identification cards as defined in ISO/IEC 7810, and the use of such cards for international interchange. ISO/IEC 14443-4:2008 specifies a half-duplex block transmission protocol featuring the special needs of a contactless environment and defines the activation and deactivation sequence of the protocol. ISO…

ISO 6709:2008 is applicable to the interchange of coordinates describing geographic point location. It specifies the representation of coordinates, including latitude and longitude, to be used in data interchange. It additionally specifies representation of horizontal point location using coordinate types other than latitude and longitude. It also specifies the representation of height and depth…